oil dipstick YAMAHA BIG BEAR PRO 400 2004 Manuale de Empleo (in Spanish)

8-13 1. Engine oil filler cap
1. Bouchon de remplissage d’huile de moteur
1. Tapa del orificio de llenado de aceite de motor
1. Dipstick 2. Maximum level mark
3. Minimum level mark
1. Jauge 2. Repère de niveau maximum
3. Repère de niveau minimum
1. Varilla 2. Marca de nivel máximo
3. Marca de nivel minimo
EBU12332
Engine oil
Engine oil level measurement
1. Place the ATV on a level surface.
2. Warm up the engine for several minutes, and
then stop it.
3. Remove the engine oil filler cap and wipe off
the dipstick with a clean rag. Insert the dip-
stick in the filler hole without screwing it in.NOTE:_ Wait a few minutes until the oil level settles before
checking. _4. Remove the dipstick and check the oil level.
5. The oil level should be between the minimum
and maximum level marks. If the engine oil is
below the minimum level mark, add sufficient
oil of the recommended type to raise it to the
correct level.CAUTION:_ Make sure that no foreign material enters the
crankcase. _
U4SH6B.book Page 13 Tuesday, May 27, 2003 4:39 PM