oil dipstick YAMAHA BIG BEAR PRO 400 2005 Manuale de Empleo (in Spanish)
[x] Cancel search | Manufacturer: YAMAHA, Model Year: 2005, Model line: BIG BEAR PRO 400, Model: YAMAHA BIG BEAR PRO 400 2005Pages: 398, tamaño PDF: 16.52 MB
Page 268 of 398
8-17 1. Engine oil filler cap
1. Bouchon de remplissage d’huile de moteur
1. Tapa del orificio de llenado de aceite de motor
1. Dipstick 2. Maximum level mark
3. Minimum level mark
1. Jauge 2. Repère de niveau maximum
3. Repère de niveau minimum
1. Varilla 2. Marca de nivel máximo
3. Marca de nivel minimo
EBU12334
Engine oil and oil filter element
The engine oil level should be checked before
each ride. In addition, the oil must be changed and
the oil filter element cleaned at the intervals speci-
fied in the periodic maintenance and lubrication
chart.
To check the engine oil level
1. Place the ATV on a level surface.
2. Warm up the engine for several minutes, and
then turn it off.
3. Wait a few minutes until the oil level settles
before checking.
4. Remove the engine oil filler cap, and then
wipe the dipstick off with a clean rag. Insert
the dipstick in the filler hole (without screwing
it in), and then remove it again to check the oil
level.NOTE:_ The oil level should be between the minimum and
maximum level marks. _
U1C160.book Page 17 Wednesday, May 12, 2004 4:55 PM
Page 270 of 398
8-19 1. Engine oil drain bolt 2. O-ring
3. Compression spring 4. Oil strainer
1. Boulon de vidange de l’huile 2. Joint torique
3. Ressort de compression 4. Crépine à huile
1. Perno de drenaje del aceite de motor 2. Junta tórica
3. Muelle de compresión 4. Colador de aceite
1. Clamp
1. Bride
1. Mordaza
5. If the engine oil is at or below the minimum
level mark, add sufficient oil of the recom-
mended type to raise it to the correct level.CAUTION:_ Make sure that no foreign material enters the
crankcase. _6. Insert the dipstick into the oil filler hole, and
then tighten the engine oil filler cap.
To change the engine oil (with or without oil fil-
ter element cleaning)
1. Place the ATV on a level surface.
2. Warm up the engine for several minutes, and
then turn it off.
3. Place a container under the engine to collect
the used oil.
4. Remove the engine oil filler cap, and then re-
move the engine oil drain bolt to drain the oil
from the crankcase.
U1C160.book Page 19 Wednesday, May 12, 2004 4:55 PM