length YAMAHA BLASTER 200 2005 Notices Demploi (in French)

4-33
EBU12881
Rear shock absorber adjustment
The spring preload can be adjusted to suit the
rider’s weight and riding conditions.
Adjust the spring preload as follows.
1. Loosen the locknut.
2. To increase the spring preload, turn the
adjusting nut in direction a. To decrease
the spring preload, turn the adjusting nut in
direction b.
cC
Never attempt to turn the adjusting nut
beyond the maximum or minimum setting.
NOTE:
A special wrench can be obtained at a Yamaha
dealer to make this adjustment.
3. The length of the spring changes 1 mm per
turn of the adjusting nut.
q
w
b
a
a
1. Adjusting nut 2. Locknut1. Écrou de réglage 2. Contre-ècrou1. Tuerca de ajuste 2. Contratuerca
a. Spring length
a. Longueur du ressorta. Longitud del resorte
Measurement A:
Installed length:
Standard: 230 mm
Minimum (hard): 222 mm
Maximum (soft): 234 mm
5VM-9-62-02 3/12/04 4:13 PM Page 34

8-65
A
a
b 1
2
A. Cable lengthA. Longueur du câbleA. Longitud del cable
1. Locknut 2. Adjusting bolt
1. Contre-écrou 2. Boulon de réglage1. Contratuerca 2. Perno de ajuste
EBU01192
Parking brake adjustment
Parking brake adjustment may be required if the
parking brake does not hold properly. The cable
length “A” should be adjusted to 64–68 mm.
1. Fully loosen the locknut and the adjusting
bolt at the clutch lever.
2. Loosen the locknut and the adjusting bolt at
the rear brake caliper.
3. Turn the adjusting bolt at the clutch lever in
direction ato increase the cable length or
in direction bto decrease the cable length.
NOTE:
If the cable cannot be adjusted to specification,
consult a Yamaha dealer.
4. Tighten the locknut at the clutch lever.
5VM-9-62-05 3/12/04 4:15 PM Page 66

10-1
Model YFS200
Dimensions:
Overall length 1,735 mm
Overall width 1,035 mm
Overall height 1,040 mm
Seat height 740 mm
Wheelbase 1,100 mm
Ground clearance 120 mm
Minimum turning radius 3,000 mm
Basic weight:
With oil and full fuel tank 155 kg
Engine:
Engine type Air-cooled 2-stroke
Cylinder arrangement Forward-inclined single cylinder
Displacement 195 cm
3
Bore × stroke 66 ×57 mm
Compression ratio 6.6 : 1
Starting system Kick starter
Lubrication system Separate lubrication (Yamaha Autolube)
EBU00428
SPECIFICATIONS
5VM-9-62-06 2/18/04 1:20 PM Page 12