tire type YAMAHA BLASTER 200 2006 Owners Manual

2-13
8Never attempt to operate over large obsta-
cles, such as large rocks or fallen trees.
Always follow proper procedures when oper-
ating over obstacles as described in this man-
ual.
8Always be careful when skidding or sliding.
Learn to safely control skidding or sliding by
practicing at low speeds and on level, smooth
terrain. On extremely slippery surfaces, such
as ice, go slowly and be very cautious in
order to reduce the chance of skidding or slid-
ing out of control.
8Never operate an ATV in fast flowing water or
in water deeper than that recommended in
this manual. Remember that wet brakes may
have reduced stopping ability. Test your
brakes after leaving water. If necessary, apply
them several times to let friction dry out the
linings.
8Always use the size and type of tires specified
in this manual.
5VM-9-63-01 3/29/05 4:00 PM Page 48

5-19
EBU00158
Tires
Always use the recommended tires.
w
Use of improper tires on this ATV, or opera-
tion of this ATV with improper or uneven tire
pressure, may cause loss of control, increas-
ing your risk of accident.
Pay attention to the following.
1. The tires listed below have been
approved by Yamaha Motor Co., Ltd. for
this model. Other tire combinations are
not recommended.
2. The tires should be set to the recom-
mended pressure:
8Recommended tire pressure
Front 30 kPa (0.30 kg/cm
2, 0.30 bar)
Rear 25 kPa (0.25 kg/cm2, 0.25 bar)
Manufacturer Size Type
FrontDUNLOP AT21 ×7–10 KT851A
CHENG SHIN AT21 ×7–10 C873N
RearDUNLOP AT21 ×10–8 KT895A
CHENG SHIN AT21 ×10–8 C874N
5VM-9-63-02 3/29/05 4:01 PM Page 56

7-15
w
Always use the size and type tires specified
in the Owner’s Manual for this vehicle on
pages 5-19–5-21. Always maintain proper tire
pressure as described in the Owner’s Manual
on page 5-23. Use of improper tires on this
ATV, or operation of this ATV with improper
or uneven tire pressure, may cause loss of
control, increasing your risk of an accident.
Do not operate at speeds too fast for your
skills or the conditions.
w
Always go at a speed that is proper for the
terrain, visibility and operating conditions,
and your experience. Operating this ATV at
speeds too fast for your skills or the condi-
tions increases your chances of losing con-
trol of the ATV, which can result in an acci-
dent.
5VM-9-63-04 3/29/05 6:52 PM Page 16

8-20
Changement de l’huile de boîte de vitesses
1. Placer la machine sur une surface de niveau.
2. Faire chauffer le moteur pendant quelques
minutes, puis le couper.
3. Placer un bac à vidange sous le moteur afin
de recueillir l’huile usagée.
4. Retirer le bouchon de l’orifice de remplissa-
ge et le boulon de vidange, puis vidanger
l’huile.
5. Remonter le boulon de vidange et le serrer
au couple spécifié.
6. Remplir le moteur de l’huile du type recom-
mandé et remettre le bouchon de remplissa-
ge en place.Cambio del aceite de la transmisión
1. Ponga la máquina sobre una superficie
nivelada.
2. Deje que se caliente el motor durante unos
minutos y párelo.
3. Coloque un recipiente debajo del motor
para el aceite usado.
4. Extraiga la tapa de relleno de aceite y el
perno de drenaje para drenar el aceite.
5. Instale el perno de drenaje y apriételo a la
torsión del par de apriete especificado.
6. Llene de aceite recomendado el motor e
instale la tapa de relleno. Par de apriete:
Perno de drenaje:
20 Nm (2,0 m0kgf)
Couple de serrage
Boulon de vidange:
20 Nm (20 m0kgf)
5VM-9-63-05 3/29/05 4:03 PM Page 21

10-4
Model YFS200
Gear ratio
1st 34/11 (3.091)
2nd 31/14 (2.214)
3rd 25/15 (1.667)
4th 20/16 (1.250)
5th 19/18 (1.056)
6th 19/21 (0.905)
Chassis:
Frame type Steel tube frame
Caster angle 9°
Trail 40 mm
Tire:
Type Tubeless
Size front AT21 ×7 - 10
rear AT21 ×10 - 8
Brake:
Front brake type Dual disk brake
operation Right hand operation
Rear brake type Single disc brake
operation Right foot operation
5VM-9-63-06 3/29/05 4:04 PM Page 15