parking brake YAMAHA BREEZE 2002 Manuale de Empleo (in Spanish)

7-37
With the engine idling, pull the clutch lever to
disengage the clutch and shift into 1st gear, and
then release the parking brake. Open the throttle
gradually, and at the same time, release the
clutch lever slowly. Once the ATV has attained
adequate speed, release the throttle lever and at
same time, quickly pull in the clutch lever and
shift into 2nd gear. Open the throttle part way
and gradually release the clutch. Use this same
procedure as you move into the higher gears.
Be sure to coordinate the use of the throttle and
shift pedal properly. If the throttle is applied too
abruptly or if the throttle is not released during
shifting, or if the shift pedal is not released
before applying the throttle, the front wheels
may lift off the ground resulting in a loss of direc-
tional control. Avoid higher speeds until you are
thoroughly familiar with the operation of your
ATV.
5KJ-62 (7 shou) 4/23/01 3:06 PM Page 38

7-57
w
Use proper gear and maintain steady speed
when climbing a hill.
If you lose all forward speed:
8Keep weight uphill.
8Apply the brakes.
8Lock parking brake, after you are stopped.
If you begin rolling backwards:
8Keep weight uphill.
8Never apply the rear brake while rolling
backwards. Apply the front brake.
When fully stopped, apply rear brake as
well, and then lock parking brake.
Dismount on uphill side or to a side if point-
ed straight uphill. Turn the ATV around and
remount, following the procedure described
in the Owner’s Manual.
5KJ-62 (7 shou) 4/23/01 3:06 PM Page 58

8-55
EBU00595
Parking brake adjustment
Parking brake adjustment may be required if the
parking brake does not hold properly.
1. Loosen the locknut of the parking brake
cable.
2. Turn the adjusting bolt until there is little or
no free play.
3. Tighten the locknut.
w
Operating with improperly adjusted brakes
could cause the brakes to malfunction
resulting in reduced braking performance.
This could increase the chance of a collision
or accident.
After adjusting the parking brake, block the
rear of the machine off the ground and spin
the rear wheels. Check to make sure there is
no brake drag. If brake drag is noticed, per-
form the adjustment again.
wq
1. Adjusting bolt 2. Locknut1. Boulon de réglage 2. Contre-écrou1. Perno de ajuste 2. Contratuerca
5KJ-62 (8 shou) 4/23/01 3:08 PM Page 56