low beam YAMAHA BREEZE 2002 Notices Demploi (in French)

Spark plug inspection .........................8-21
Air filter cleaning .................................8-25
Carburetor settings .............................8-33
Idle speed adjustment ........................8-45
Throttle lever adjustment ....................8-47
Front brake shoe inspection ...............8-49
Rear brake pad inspection .................8-49
Front brake lever free play
adjustment ........................................8-51
Parking brake adjustment ...................8-55
Adjusting the rear brake light switch ...8-57
Clutch adjustment ...............................8-59
Autolube pump adjustment .................8-59
Drive chain slack check ......................8-61
Drive chain slack adjustment ..............8-63
Lubricating the drive chain .................8-65
Cable inspection and lubrication ........8-69
Brake and shift pedal/brake and
clutch lever lubrication ......................8-71
Upper arm and lower arm pivot
lubrication .........................................8-71Steering shaft lubrication ....................8-73
Wheel removal ...................................8-73
Wheel installation ...............................8-73
Replacing the headlight bulb ..............8-75
Headlight beam adjustment ................8-79
Tail/brake light bulb replacement .......8-81
Troubleshooting ..................................8-83
Troubleshooting chart .........................8-87
CLEANING AND STORAGE....................9-1
A. Cleaning ...........................................9-1
B. Storage ............................................9-7
SPECIFICATIONS .................................10-1
HOW TO USE THE CONVERSION
TABLE ....................................................11-1
9
10
11
5KJ-62 (0~3 shou) 4/23/01 3:03 PM Page 14

4-9
EBU00053
Handlebar switches
EBU00054
Engine stop switch “ENG. STOP”
Make sure that the engine stop switch is in the
“RUN” position. The engine stop switch controls
ignition and can be used at all times to stop the
engine, especially in an emergency. The engine
will not start or run when the engine stop switch
is turned to “OFF”.
EBU00736
Light switch “LIGHTS”
Turn the switch to the “LO” position to switch on
the low beam and the taillight.
Turn the switch to the “HI” position to switch on
the high beam and the taillight.
Turn the switch to the “OFF” position to switch
off the headlight and the taillight.
NOTE:
The headlight and the taillight can be turned on
only when the engine is started.
q
w
1. Lights switch “LIGHTS”
2. Engine stop switch “ENG. STOP”
1. Contacteur d’éclairage “LIGHTS”
2. Coupe-circuit du moteur “ENG. STOP”
1. Interruptor de luces “LIGHTS”
2. Interruptor de paro del motor “ENG. STOP”
5KJ-62 (4~5 shou) 4/23/01 3:04 PM Page 10