warning YAMAHA FX 2006 Owners Manual

E
EJU21830
To the owner/operator
Thank you for choosing a Yamaha water-
craft.
This Owner’s/Operator’s Manual contains
information you will need for proper opera-
tion, maintenance, and care. If you have any
questions about the operation or mainte-
nance of your watercraft, please consult a
Yamaha dealer.
This manual is not a course on boating
safety or seamanship. If this is your first
watercraft, or if you are changing to a type of
watercraft you are not familiar with, for your
own comfort and safety, please ensure that
you obtain proper training or practice before
operating the watercraft by yourself. In addi-
tion, a Yamaha dealer or boating organiza-
tion will be pleased to recommend local sea
schools, or competent instructors.
Because Yamaha has a policy of continu-
ing product improvement, this product may
not be exactly as described in this Owner’s/
Operator’s Manual. Specifications are sub-
ject to change without notice.
This manual should be considered a per-
manent part of this watercraft and should
remain with it even if the watercraft is subse-
quently sold. EJU01204
Important manual information:
In this manual, information of particular
importance is distinguished in the following
ways:
The Safety Alert Symbol means
ATTENTION! BECOME ALERT!
YOUR SAFETY IS INVOLVED!
WARNING@ Failure to follow WARNING instructions
could result in severe injury or death to
the machine operator, passengers, a
bystander, or a person inspecting or
repairing the watercraft.
@
CAUTION:@ A CAUTION indicates special precau-
tions that must be taken to avoid damage
to the watercraft.
@
NOTE:@ A NOTE provides key information to make
procedures easier or clearer.
@
EJU00991
WaveRunner FX/FX Cruiser
OWNER’S/OPERATOR’S MANUAL
©2005 by Yamaha Motor Co., Ltd.
1st Edition, August 2005
All rights reserved.
Any reprinting or unauthorized use
without the written permission of
Yamaha Motor Co., Ltd.
is expressly prohibited.
Printed in USA
E_F1Y-70.book Page 1 Friday, August 26, 2005 9:47 AM

E
1
EJU00993
GENERAL AND
SAFETY
INFORMATION
Identification numbers ............................ 1-1
Primary Identification (PRI-ID)
number ................................................... 1-1
Hull Identification Number (HIN) ............ 1-2
Engine serial number ............................. 1-2
Model information ................................... 1-3
Builder’s plate ......................................... 1-3
Emission control information
(For Canada only) .................................... 1-4
Approval label of Emission control
certificate ................................................ 1-4
Manufactured date label ........................ 1-4
Important labels ....................................... 1-5
Label location ......................................... 1-5
Warning labels ....................................... 1-6
Other labels .......................................... 1-10
Safety information ................................. 1-12
Limitations on who may operate
the watercraft ....................................... 1-12
Cruising limitations ............................... 1-13
Operation requirements ....................... 1-14
Recommended equipment .................. 1-16
Hazard information .............................. 1-17
Watercraft characteristics .................... 1-17
Water-skiing ......................................... 1-18
Safe boating rules ................................. 1-20
Enjoy your watercraft responsibly ...... 1-20
E_F1Y-70.book Page 1 Friday, August 26, 2005 9:47 AM

1-6
E
EJU19892
Warning labels
1
E_F1Y-70.book Page 6 Friday, August 26, 2005 9:47 AM

1-12
E
EJU00999
Safety information
The safe use and operation of this
watercraft is dependent upon the use of
proper riding techniques, as well as upon
the common sense, good judgment, and
expertise of the operator. Before using
this watercraft, make sure that its use is
permitted under local laws, bylaws and
regulations and always operate the
watercraft in full conformity with any
requirements and limitations imposed.
Every operator should know the follow-
ing requirements before riding the water-
craft.

Before operating the watercraft, read this
Owner’s/Operator’s Manual, the Riding
Practice Guide, and all warning and cau-
tion labels on the watercraft. These mate-
rials should give you an understanding of
the watercraft and its operation.

Never allow anyone to operate this water-
craft until they too have read this Owner’s/
Operator’s Manual, the Riding Practice
Guide and all warning and caution labels.
EJU01207
Limitations on who may
operate the watercraft

Yamaha recommends a minimum opera-
tor age of 16 years old.
Adults must supervise use by minors.
Know your local operator age and training
requirements.

This watercraft is designed to carry the
operator and up to 2 passengers. Never
exceed the maximum load limit or allow
more than 3 persons (or 2 persons if a
water-skier is being pulled) to ride the
watercraft at one time.

Do not operate the watercraft with any
passengers on board until you have con-
siderable practice and experience riding
alone. Operating the watercraft with pas-
sengers requires more skill. Take the time
to become accustomed to the handling
characteristics of the watercraft before
trying any difficult maneuvers.
Maximum load: 240 kg (530 lb)
Load is the total weight of cargo,
operator and passengers.
E_F1Y-70.book Page 12 Friday, August 26, 2005 9:47 AM

2-8
E
EJU01016
Engine shut-off switch
Insert the clip 1, on the end of the engine
shut-off cord 2, under the engine shut-off
switch 3 (black button). The engine will stop
automatically when the clip is removed from
the switch, such as if the operator falls off
the watercraft.
WARNING@
Always attach the engine shut-off cord
to your wrist and the clip to the engine
shut-off switch BEFORE starting the
engine.

To prevent accidental starting of the
engine or unauthorized use by chil-
dren or others, always remove the clip
from the shut-off switch when the
engine is not running.
EJU01018
Throttle lever
Squeeze the throttle lever 1 to increase
engine speed.
Release the throttle lever to decrease
engine speed or to return it to the idle posi-
tion.
E_F1Y-70.book Page 8 Friday, August 26, 2005 9:47 AM

2-11
E
EJU01217
Tilt lever
The tilt lever 1 is located in front of the
glove compartment and is used to adjust the
tilt of the handlebars.
To adjust the tilt, pull the tilt lever up, and
then move the handlebars up or down to the
desired position.
WARNING@
Never touch the tilt lever during opera-
tion, otherwise the handlebars may
suddenly change position, which may
lead to an accident.

Be sure to fasten the tilt lever properly
after adjusting the handlebar position.
If the handlebars are not properly fas-
tened, they may suddenly change
position, which may lead to an acci-
dent.
E_F1Y-70.book Page 11 Friday, August 26, 2005 9:47 AM

2-12
E
EJU18771
Shift lever
The shift lever is located on the starboard
(right) side of the watercraft and is used to
control the reverse gate, which allows the
watercraft to move in reverse or forward.
When the shift lever is in the reverse posi-
tion, the watercraft can be launched from a
trailer, or backed up out of tight spots where
you cannot turn around easily.
To shift into reverse:
1. Release the throttle and let the engine
speed return to idle.
2. Pull the shift lever toward you.
WARNING@
Make sure that the throttle is com-
pletely released and that the engine is
at idle before shifting into reverse.

Do not use the reverse function to
slow down or stop the watercraft as it
could cause you to lose control, be
ejected, or impact the handlebars.

Use reverse for slow-speed maneuver-
ing only.

Make sure that there are no obstacles
or people behind you before shifting
into reverse.

Do not touch the reverse gate while the
shift lever is being operated, otherwise
you could be pinched.
@
To shift into forward:
1. Release the throttle and let the engine
speed return to idle.
2. Push the shift lever away from you.
E_F1Y-70.book Page 12 Friday, August 26, 2005 9:47 AM

2-15
E
EJU01967
Handgrip
The handgrip 1 provides a handhold for
boarding the watercraft and for a spotter
when facing rearward.
WARNING@ Do not use the handgrip to lift the water-
craft. The watercraft could fall, which
could result in severe injury.
@
EJU22230
Reboarding step (for FX
Cruiser)
The reboarding step 1 provides a hand-
hold and footstep for boarding the water-
craft.
CAUTION:@ Use the reboarding step only to board
the watercraft in the water. Do not use
the reboarding step for lifting the water-
craft, as a footstep when the watercraft is
on land, or for any other purpose. The
watercraft can be damaged.
@
E_F1Y-70.book Page 15 Friday, August 26, 2005 9:47 AM

2-17
E
EJU22350
Analog speedometer/
tachometer and indicator
lights
This watercraft is equipped with the fol-
lowing meter and indicator lights.
1
Analog speedometer/tachometer
2
“SPEED” indicator light
3
“WARNING” indicator light
4
“RPM” indicator light
EJU22250
Analog speedometer/tachometer
The analog speedometer/tachometer can
be used as a speedometer or a tachometer.
To switch between the speedometer and
the tachometer functions, push the “Speed/
RPM” button 1
for at least 1 second when
the multifunction meter is operating.
The “SPEED” indicator light 2
comes on
when the analog speedometer is selected.
The “RPM” indicator light 3
comes on when
the analog tachometer is selected.
NOTE:@ When the analog speedometer/tachometer
is switched to the speedometer function, the
“SPEED” indicator light blinks three times,
and then comes on.
@
E_F1Y-70.book Page 17 Friday, August 26, 2005 9:47 AM

2-19
E
EJU22260
“SPEED” indicator light
The “SPEED” indicator light 1 comes on
when the analog speedometer is selected.
The “SPEED” indicator light blinks three
times in the following instances:

The analog speedometer/tachometer is
switched to the speedometer function.

The display units of the multifunction
meter are switched to miles from kilome-
ters.

Miles are selected as the display units
when the multifunction meter starts oper-
ating.
EJU22000
“WARNING” indicator light
The “WARNING” indicator light 1 blinks
or comes on, together with a warning indica-
tor, when a malfunction has occurred.
E_F1Y-70.book Page 19 Friday, August 26, 2005 9:47 AM