clock YAMAHA FX HO 2006 Owners Manual
[x] Cancel search | Manufacturer: YAMAHA, Model Year: 2006, Model line: FX HO, Model: YAMAHA FX HO 2006Pages: 152, PDF Size: 11.96 MB
Page 36 of 152
2-7
E
EJU10110
Hood
To open the hood, push the latch 1
down, and then lift the hood up.
To close the hood, push the hood down to
lock it in place.
NOTE:@ Make sure that the hood is properly secured
before operating the watercraft.
@
EJU10120
Fuel tank filler cap
To remove the fuel tank filler cap 1, turn it
counterclockwise.
NOTE:@ Make sure that the fuel tank filler cap is
properly secured before operating the water-
craft.
@
E_F1X-70.book Page 7 Friday, August 26, 2005 11:00 AM
Page 67 of 152
2-38
E
EJU22120
Beverage holder
The beverage holder 1 is located on the
starboard (right) side of the watercraft.
NOTE:@ Do not use the beverage holder when oper-
ating the watercraft.
@
EJU22130
Watertight compartment
A watertight compartment is located on
the port (left) side of the watercraft.
To open the watertight compartment, turn
the cap 1 counterclockwise.
Make sure that the watertight compart-
ment cap is closed securely before operat-
ing the watercraft.
Watertight compartment:
Capacity: 2.6 L (0.7 US gal, 0.6 Imp gal)
Load limit: 1.0 kg (2.2 lb)
E_F1X-70.book Page 38 Friday, August 26, 2005 11:00 AM
Page 80 of 152
3-11
E
EJU18640
Fire extinguisher
Check that there is a full fire extinguisher
on board. The fire extinguisher container 1
is located in the seat storage compartment.
To open the fire extinguisher container
cap 2, turn it counterclockwise.
After inserting the fire extinguisher make
sure that the container cap is tightened
securely.
NOTE:@ See the instructions supplied by the fire
extinguisher manufacturer for checking
the fire extinguisher. Always keep the
extinguisher in the fire extinguisher con-
tainer.
Always carry a fire extinguisher on board.
A fire extinguisher is not standard equip-
ment with this watercraft. If you do not
have one, contact a Yamaha dealer or a
fire extinguisher dealer to obtain one
meeting the proper specifications.
@
E_F1X-70.book Page 11 Friday, August 26, 2005 11:00 AM
Page 98 of 152
3-29
E
EJU18102
Capsized watercraft
If the watercraft capsizes, turn it over
immediately.
Be sure to carefully follow the procedures
below to prevent injury or damage to the
watercraft.
WARNING@ IMPROPER UPRIGHTING CAN CAUSE
INJURY:
Make sure that the engine shut-off
cord is removed from the engine shut-
off switch.
Do not put your hands in the intake
grate.
Watch so you are not hit by the water-
craft as it comes over.
@
CAUTION:@ If the watercraft capsizes, release the
throttle lever immediately. Oil could flow
into the air filter case and the engine
could be damaged.
@
1. Remove the clip from the engine shut-off
switch.
2. Swim to the rear of the watercraft. Pull
the watercraft over with your left hand on
the ride plate while pushing down on the
gunwale with your right hand or foot.
NOTE:@ If the port (left) side of the capsized water-
craft is tilting up, push down on the gunwale
so that the port (left) side is down before
turning the watercraft clockwise.
@
CAUTION:@ Do not turn the watercraft over counter-
clockwise, otherwise water can leak into
the engine, which can result in severe
damage.
@
E_F1X-70.book Page 29 Friday, August 26, 2005 11:00 AM
Page 135 of 152
4-26
E
DRIVE UNIT
Propulsion system Jet pump
Jet pump type Axial flow, single stage
Impeller rotation Counterclockwise (viewed from rear)
Jet thrust nozzle horizontal angle Degree 24 + 24
Jet thrust nozzle trim angle Degree -10, -5, 0, 5, 10
FUEL AND OIL
Recommended fuel Regular unleaded gasoline
Minimum octane rating PON
RON86
90
Recommended engine oil SAE 10W-30
API SE, SF, SG, SH, SJ, SL
Fuel tank capacity
Total L (US gal, Imp gal) 70 (18.5, 15.5)
Engine oil quantity
With oil filter replacement L (US qt, Imp qt) 2.3 (2.4, 2.0)
Without oil filter replacement L (US qt, Imp qt) 2.1 (2.2, 1.8)
Total amount L (US qt, Imp qt) 4.5 (4.8, 4.0)MODEL
ITEMUnit FX High Output/FX Cruiser High Output
E_F1X-70.book Page 26 Friday, August 26, 2005 11:00 AM