seats YAMAHA FX HO 2010 User Guide

Maintenance
87
EJU33768
Maintenance
Periodic checks and lubrication will keep your
watercraft in the safest and most efficient con-
dition possible. Therefore, make sure to carry
out the periodic maintenance. Safety is an ob-
ligation of the watercraft owner. Proper main-
tenance must be carried out to keep the
exhaust emission and sound levels within the
regulated limits. The most important points of
watercraft inspection and lubrication are ex-
plained on the following pages.
See a Yamaha dealer for genuine Yamaha re-
placement parts and optional accessories de-
signed for your watercraft.
Remember, failures that are the result of the
installation of parts or accessories which are
not qualitatively equivalent to genuine
Yamaha parts are not covered by the limited
warranty.
Maintenance, replacement, or repair of the
emission control devices and system may
be performed by any marine SI engine re-
pair establishment or individual. Warranty
repair, however, must be performed at an
authorized Yamaha marine dealership.
WARNING
EWJ00311
Be sure to turn off the engine when you
perform maintenance unless otherwise
specified. If you are not familiar with ma-
chine servicing, this work should be done
by a Yamaha dealer or other qualified me-
chanic.
EJU33802Tool kit
A tool kit is included with this watercraft. Place
the tool kit in a waterproof bag and alwayscarry it with you whenever you use the water-
craft.
EJU41481Removing and installing the engine
cover
The engine cover is removable.
To remove the engine cover:
(1) Remove the seats. (See page 45 for seat
removal and installation procedures.)
(2) Open the plastic tie that is securing the
breather hose.
1Tool bag
2Screwdriver
316 mm box wrench
4Garden hose adapter
510/12 mm box wrench
6Pliers
7Open-end wrench
UF2H71E0.book Page 87 Thursday, July 2, 2009 10:05 AM

Maintenance
89
then secure the breather hose to the en-
gine cover by closing the plastic tie.
(4) Securely install the seats in their original
positions.
1Corrugated tube
1Plastic tie
1
1
UF2H71E0.book Page 89 Thursday, July 2, 2009 10:05 AM

Trouble recovery
97
(2) Remove any weeds or debris from
around the jet intake, drive shaft, impel-
ler, jet pump housing, and jet thrust noz-
zle.
If debris is difficult to remove, consult a
Yamaha dealer.
EJU34641Jumping the battery
If the watercraft battery has run down, the en-
gine can be started using a 12-volt booster
battery and jumper cables.
EJU34663Connecting the jumper cables
WARNING
EWJ01250
To avoid battery explosion and serious
damage to the electrical system:

Do not reverse the polarity of the jumper
cables when connecting to the batteries.

Do not connect the negative (–) jumper
cable to the negative (–) terminal of the
watercraft battery.

Do not touch the positive (+) jumper ca-
ble to the negative (–) jumper cable.
(1) Connect the positive (+) jumper cable to
the positive (+) battery terminals of both
batteries.
(2) Connect one end of the negative (–)
jumper cable to the negative (–) battery
terminal of the booster battery.(3) Connect the other end of the negative (–)
jumper cable to an engine hanger.
(4) Start the engine, and then disconnect the
jumper cables by reversing the steps
above. (See page 28 for information on
starting the engine.)
EJU36994Replacing the fuses
If a fuse is blown, replace it with the proper
fuse.
To replace a fuse:
(1) Remove the seats. (See page 45 for seat
removal and installation procedures.)
1Negative (–) jumper cable
2Positive (+) jumper cable
3Engine hanger
4Booster battery
1Good fuse
2Blown fuse
1
342
2 1
UF2H71E0.book Page 97 Thursday, July 2, 2009 10:05 AM

Trouble recovery
99
(7) Securely install the seats in their original
positions.
If the fuse immediately blows again, the elec-
trical system may be defective. If this occurs,
have a Yamaha dealer service the watercraft.
EJU34715Towing the watercraft
WARNING
EWJ00811

The operator of the towing boat must
keep speed to a minimum and avoid traf-
fic or obstacles which could be a hazard
to the operator on the watercraft.

The towline should be long enough so
that the watercraft will not collide with
the towing boat when slowing down.
If the watercraft becomes inoperative in the
water, it can be towed to shore.
To tow the watercraft:
Use a towline that is three times the combined
length of the towing boat and the watercraft.
(1) Securely attach the towline to the bow
eye of the watercraft being towed.
(2) Sit astride the seat and hold on to the
handlebars in order to balance the water-
craft. NOTICE: The bow must be kept
up out of the water during towing, oth-
erwise water could flood the engine
compartment or water could flow backinto the engine, causing severe en-
gine damage.
[ECJ01330]
Tow the watercraft at 8 km/h (5 mph) or less.
NOTICE: Tow the watercraft at 8 km/h (5
mph) or less, otherwise water could flood
the engine compartment or water could
flow back into the engine, causing severe
engine damage.
[ECJ01321]
EJU36154
Submerged watercraft
If the watercraft is submerged or flooded with
water, drain the water from the engine com-
partment. Then, have a Yamaha dealer ser-
vice the watercraft as soon as possible.
If the watercraft was submerged:
(1) Remove the watercraft from the water
and drain the water from the storage
compartments. (See page 48 for informa-
tion on draining the storage compart-
ments.)
(2) Drain the water from the engine compart-
ment. (See page 55 for information on
draining the bilge water.)
(3) Have the watercraft serviced by a
Yamaha dealer as soon as possible.
NOTICE: Be sure to have a Yamaha
dealer inspect the watercraft. Other-
wise, serious engine damage could re-
sult.
[ECJ00791]
1Bow eye
UF2H71E0.book Page 99 Thursday, July 2, 2009 10:05 AM

Index
Limitations on who may operate
the watercraft ........................................ 10
Long-term storage .................................... 85
Low RPM Mode........................................ 34
Lubrication................................................ 85
M
Main components, location of .................. 22
Maintenance............................................. 87
Model information....................................... 2
Multifunction information center ............... 39
Multifunction information center check ..... 68
N
No-wake mode ......................................... 35
O
Oil pressure warning ................................ 43
Operating in weeded areas ...................... 80
Operating the watercraft........................... 71
Operating the watercraft in reverse .......... 74
Operating your watercraft......................... 69
Operation requirements ........................... 12
P
Periodic maintenance chart...................... 90
Post-launch checks .................................. 67
Post-operation care .................................. 81
Pre-launch checks.................................... 61
Pre-operation check points ...................... 61
Pre-operation checklist............................. 59
Primary Identification (PRI-ID) number ...... 1
Pull-up cleats (FX Cruiser HO)................. 48
Q
Quick Shift Trim System (Q.S.T.S.) ......... 33
Quick Shift Trim System (Q.S.T.S.)
checks................................................... 64
R
Reboarding step ....................................... 46
Recommended equipment ....................... 14
Remote control transmitter ....................... 26
Remote control transmitter check ............ 65
Reverse system ....................................... 32
Reverse system checks ........................... 64
Riding position.......................................... 70
Rustproofing ............................................. 86
S
Safe boating rules .................................... 19
Safety equipment check ........................... 67Seat storage compartment ....................... 50
Seats ........................................................ 45
Start switch............................................... 28
Starting off ................................................ 77
Starting off from a trailer ........................... 78
Starting the engine on water .................... 70
Steering system ....................................... 29
Steering system checks ........................... 63
Stern drain plug checks ............................ 67
Stern eyes ................................................ 47
Stopping the engine ................................. 71
Stopping the watercraft ............................ 73
Storage compartment checks .................. 66
Storage compartments ............................. 48
Submerged watercraft .............................. 99
Switch checks .......................................... 66
T
Throttle lever ............................................ 29
Throttle lever checks ................................ 65
Tool kit...................................................... 87
Towing the watercraft ............................... 99
Transporting on a trailer ........................... 57
Troubleshooting ....................................... 93
Troubleshooting chart .............................. 93
Turning the watercraft .............................. 72
W
Water separator ....................................... 31
Water separator check ............................. 61
Watercraft characteristics ......................... 15
Watercraft control functions ..................... 26
Watercraft operation functions ................. 32
Watercraft operation modes ..................... 34
Water-skiing ............................................. 17
Watertight storage compartment .............. 51
Y
Yamaha Security System ......................... 27
Yamaha Security System settings ........... 27
UF2H71E0.book Page 2 Thursday, July 2, 2009 10:05 AM