torque YAMAHA FX HO CRUISER 2010 Owners Manual

Maintenance
88
TIP:
Be careful not to drop the plastic tie into the
engine compartment.
(3) Remove the engine cover screws.
(4) Lift up the engine cover and remove it.To install the engine cover:(1) Lift up the breather hose so that it will not
be routed under the engine cover, place
the engine cover in its original position,
and then push it down.
(2) Install the engine cover screws, and then
tighten them to the specified torque.
(3) Slide the corrugated tube on the breather
hose toward the bow until it stops, and
1Breather hose
2Plastic tie
1Engine cover screw
1Engine cover
2 1
1
1
1Engine cover
2Breather hose
Tightening torque:
Engine cover screw:
4.5 Nm (0.46 kgf-m, 3.3 ft-lb)
1
2
UF2H71E0.book Page 88 Thursday, July 2, 2009 10:05 AM