jump cable YAMAHA FZS 2009 Owners Manual

Table of contents
Lubrication ....................................... 70
Battery ............................................. 70
Cleaning the watercraft ................... 70
Maintenance and adjustments ..... 71
Owner’s/operator’s manual and
tool kit ........................................... 71
Periodic maintenance chart ............. 72
Checking the fuel system ................ 74
Engine oil and oil filter ..................... 74
Air filter element .............................. 74
Checking the jet thrust nozzle
angle ............................................ 74
Checking the shift cable .................. 75
Checking the throttle lever ............... 75
Cleaning and adjusting the spark
plugs ............................................ 76
Lubrication points ............................ 77
Checking the battery ....................... 78
Fuel injection system ....................... 80
Specifications .................................. 81
Specifications ................................ 81
Trouble recovery ............................. 82
Troubleshooting ........................... 82
Troubleshooting chart ...................... 82
Emergency procedures ................ 85
Cleaning the jet intake and
impeller ........................................ 85
Jumping the battery ......................... 86
Replacing the fuses ......................... 86
Towing the watercraft ...................... 88
Submerged watercraft ..................... 88
UF2C70E0.book Page 2 Monday, November 3, 2008 10:16 AM

Trouble recovery
86
(2) Remove any weeds or debris from
around the jet intake, drive shaft, impel-
ler, jet pump housing, and jet thrust noz-
zle.
If debris is difficult to remove, consult a
Yamaha dealer.
EJU34641Jumping the battery
If the watercraft battery has run down, the en-
gine can be started using a 12-volt booster
battery and jumper cables.
EJU34662Connecting the jumper cables
WARNING
EWJ01250
To avoid battery explosion and serious
damage to the electrical system:

Do not reverse the polarity of the jumper
cables when connecting to the batteries.

Do not connect the negative (–) jumper
cable to the negative (–) terminal of the
watercraft battery.

Do not touch the positive (+) jumper ca-
ble to the negative (–) jumper cable.
(1) Connect the positive (+) jumper cable to
the positive (+) battery terminals of both
batteries.
(2) Connect one end of the negative (–)
jumper cable to the negative (–) battery
terminal of the booster battery.(3) Connect the other end of the negative (–)
jumper cable to an engine hanger.
(4) Start the engine, and then disconnect the
jumper cables by reversing the steps
above. NOTICE: Never push the start
switch while the engine is running. Do
not operate the start switch for more
than 5 seconds, otherwise the battery
will be discharged and the engine will
not start. Also, the starter motor could
be damaged. If the engine does not
start in 5 seconds, release the start
switch, wait 15 seconds, and then try
again.
[ECJ00481]
EJU36991
Replacing the fuses
The fuses are located in the electrical box.
To replace a fuse:
(1) Remove the seats. (See page 24 for seat
removal and installation procedures.)
1Negative (–) jumper cable
2Positive (+) jumper cable
3Booster battery
4Engine hanger
2
3 1
4
UF2C70E0.book Page 86 Monday, November 3, 2008 10:16 AM

Index
A
Air filter element ....................................... 74
B
Battery ................................................ 49, 70
Battery, checking...................................... 78
Battery, jumping ....................................... 86
Beaching the watercraft ........................... 66
Bilge ......................................................... 49
Boarding alone ......................................... 61
Boarding and starting from a dock ........... 60
Boarding and starting in deep water ........ 60
Boarding and starting in shallow water .... 60
Boarding with passengers ........................ 61
Bow down................................................. 31
Bow eye ................................................... 32
Bow up ..................................................... 31
Builder’s plate............................................. 2
C
Capsized watercraft ................................. 63
Check engine warning.............................. 39
Cleaning the watercraft ............................ 70
Cooling water pilot outlets .................. 28, 54
Craft Identification Number (CIN) ............... 1
Cruising limitations ................................... 11
D
Docking the watercraft ............................. 66
Dual analog meter unit ....................... 35, 54
E
Emergency procedures ............................ 85
Engine break-in ........................................ 55
Engine compartment ................................ 47
Engine oil ................................................. 44
Engine oil and oil filter .............................. 74
Engine oil level ......................................... 47
Engine overheat warning ......................... 38
Engine serial number ................................. 1
Engine shut-off cord (lanyard) .................. 53
Engine shut-off switch .............................. 26
Engine stop switch ................................... 26
Enjoy your watercraft responsibly ............ 19
F
Fire extinguisher....................................... 50
Flushing the cooling system ..................... 69
Front storage compartment ...................... 39
Fuel .......................................................... 43Fuel and oil............................................... 43
Fuel injection system ................................ 80
Fuel level .................................................. 47
Fuel level meter ........................................ 37
Fuel level warning .................................... 37
Fuel system, checking .............................. 74
Fuel tank .................................................. 74
Fuel tank filler cap .................................... 25
Fuses, replacing ....................................... 86
G
Getting to know your watercraft ............... 58
Glove compartment .................................. 40
H
Handgrips ................................................. 31
Hazard information ................................... 15
Hood ......................................................... 25
Hour meter/voltmeter ............................... 36
Hull and deck ........................................... 47
I
Identification numbers ................................ 1
Information display ................................... 36
J
Jet intake .................................................. 53
Jet intake and impeller, cleaning .............. 85
Jet thrust nozzle angle, checking ............. 74
Jumper cables, connecting ...................... 86
L
Labels, important ........................................ 3
Labels, other .............................................. 8
Labels, warning .......................................... 4
Launching the watercraft .......................... 55
Learning to operate your watercraft ......... 58
Leaving the watercraft .............................. 57
Limitations on who may operate the
watercraft .............................................. 10
L-MODE (low-RPM mode) ....................... 33
Lubrication................................................ 70
Lubrication points ..................................... 77
M
Main components, location of .................. 20
Maintenance and adjustments ................. 71
Model information....................................... 2
O
Oil pressure warning ................................ 37
Operating in weeded areas ...................... 67
UF2C70E0.book Page 1 Monday, November 3, 2008 10:16 AM