brake YAMAHA GRIZZLY 125 2004 Notices Demploi (in French)

7-65
CROSSING THROUGH SHALLOW WATER
The ATV can be used to cross slow moving,
shallow water of up to a maximum of 20 cm (7.9
inches) in depth. Before entering the water,
choose your path carefully. Enter where there is
no sharp drop off, and avoid rocks or other
obstacles which may be slippery or upset the
ATV. Drive slowly and carefully.
w
Never operate this ATV in fast flowing water
or in water deeper than that specified in your
Owner’s Manual. Remember that wet brakes
may have reduced stopping ability. Test your
brakes after leaving water. If necessary,
apply them several times to let friction dry
out the linings. If the ATV is operated
through deep or fast flowing water, the tires
may float, causing loss of traction and loss
of control, which could lead to an accident.
1C5-9-60-07 11/12/03 7:24 PM Page 66

7-67
Test your brakes after leaving the water. Do not
continue to ride your ATV without verifying that
you have regained proper braking ability.
cC
After riding your ATV in water, be sure to
drain the trapped water by removing the
check hose at the bottom of the air filter
case. Wash the ATV in fresh water if it has
been operated in salt water or muddy condi-
tions.
q
1. Check hose1. Flexible de contrôle1. Manguito de retención
1C5-9-60-07 11/12/03 7:24 PM Page 68

7-71
SLIDING AND SKIDDING
Care should be used when riding on loose or
slippery surfaces since the ATV may slide. If
unexpected and uncorrected, sliding could lead
to an accident. To reduce the tendency for the
front wheels to slide in loose or slippery condi-
tions, positioning your weight over the front
wheels will sometimes help.
If the rear wheels of your ATV start to slide side-
ways, control can usually be regained (if there is
room to do so) by steering in the direction of the
slide. Applying the brakes or accelerating is not
recommended until you have corrected the
slide.
1C5-9-60-07 11/12/03 7:24 PM Page 72

7-77
8If your ATV starts to slide sideways:
Steer in the direction of the slide if you have
the room.
Applying the brakes or accelerating is not rec-
ommended until you have corrected the slide.
(See pages 7-71–7-73.)
8If your ATV can’t make it up a hill you are try-
ing to climb:
Turn the ATV around if you still have forward
speed. If not, stop, dismount on the uphill side
of the ATV and physically turn the ATV
around. If the ATV starts to slip backwards
DO NOT USE THE REAR BRAKE - the ATV
may tip over on top of you. Dismount the ATV
on the uphill side. (See pages 7-45–7-55.)
1C5-9-60-07 11/12/03 7:24 PM Page 78

7-79
8If your ATV is traversing a sloping surface:
Be sure to ride with your weight positioned
towards the uphill side of the ATV to maintain
proper balance. If the ATV starts to tip, steer
down the hill (if there are no obstacles in your
way) to regain balance. If you discover that
the ATV is going to tip over, dismount on the
uphill side. (See pages 7-61–7-63.)
8If your ATV encounters shallow water:
Ride slowly and carefully through slow mov-
ing water, watching for obstacles. Be sure to
let water drain from the ATV and CHECK
YOUR BRAKES FOR PROPER OPERATION
when you come out of the water. Do not con-
tinue to ride your ATV until you have regained
adequate braking ability. (See pages 7-65–
7-67.)
1C5-9-60-07 11/12/03 7:24 PM Page 80

8-8 * It is recommended that these items be serviced by a Yamaha dealer.
INITIAL EVERY
ITEM ROUTINE
13661
monthmonths months monthsyear
Brakes*• Check operation.
11111
• Adjust if necessary.
V-belt*• Check operation.
11
• Replace if damage or excessive wear.
Wheels*• Check balance/damage/runout.
1111
• Replace if necessary.
Wheel bearings*• Check bearing assembly for looseness/damage.
1111
• Replace if damaged.
• Check operation.
Steering system*• Replace if damaged.
11111
• Check toe-in.
• Adjust if necessary.
Knuckle shafts/
• Lubricate every 6 months with lithium-soap-based grease.111
steering shaft*
Fittings and fasteners*• Check all chassis fittings and fasteners.
11111
• Correct if necessary.
• Check specific gravity.
Battery*• Check breather hose for correct routing.11111
• Correct if necessary.
1C5-9-60-08 9/12/03 8:38 PM Page 8-9

8-47
EBU00308
Front and rear brake shoe inspection
A wear indicator is provided on each brake. The
indicators allows checking of brake shoe wear
without disassembling the brake. Apply the
brake and check the position of the indicator. If
the indicator reaches the wear limit line, ask a
Yamaha dealer to replace the shoes as a set.
w
q
q
w
1. Wear limit line 2. Wear indicator1. Ligne de limite d’usure 2. Indicateur d’usure1. Línea de límite de desgaste 2. Inidcador de desgaste
1. Wear limit line 2. Wear indicator
1. Ligne de limite d’usure 2. Indicateur d’usure1. Línea de límite de desgaste 2. Inidcador de desgaste
FrontAvantDelantero
RearArrièreTrasero
1C5-9-60-08 9/12/03 8:38 PM Page 8-48

EBU14882
Front brake lever free play adjustment
NOTE:
Before adjusting the brake lever free play,
inspect the front brake shoes.
The front brake lever free play should be adjust-
ed to 5–8 mm at the brake lever pivot. If the free
play is incorrect, adjust it as follows.
1. Remove the front carrier by removing the
bolts.
a
a. Free playa. Jeua. Juego
1
2
2
2
1. Front carrier 2. Bolt (×6)1. Porte-bagages avant 2. Boulon (×6)1. Portapaquetes delantero 2. Tapón (×6)
8-49
1C5-9-60-08 9/12/03 8:38 PM Page 8-50

4. Loosen the locknut and fully turn in the
adjusting bolt at the front brake lever.
5. Make sure the brake cable joint in the equal-
izer is straight when the brake is applied. If
not, loosen the locknut, and then turn the
adjusting nuts at the front brake cables until
the cable joint becomes straight.
aa’
a=a’
1 2
8-53 1. Equalizer 2. Cable joint
1. Égaliseur 2. Raccord de câble1. Ecualizador 2. Conexión del cable
q
w
1. Locknut 2. Adjusting bolt1. Contre-écrou 2. Dispositif de réglage1. Contratuerca 2. Ajustador
1C5-9-60-08 9/12/03 8:38 PM Page 8-54

6. Tighten the locknut of each brake cable.
7. Turn the adjusting bolt at the brake lever
until the specified free play is obtained.
8. Tighten the locknut at the brake lever.
a
q
w
Specified free play:
5–8 mm
8-55 1. Locknut 2. Adjusting nut
a. Free play
1. Contre-écrou 2. Dispositif de réglage
a. Jeu
1. Contratuerca 2. Dispositivo de ajuste
a. Juego
q
w
q
w
1. Locknut (×2) 2. Adjusting nut (×2)1. Contre-écrou (×2) 2. Dispositif de réglage (×2)1. Contratuerca (×2) 2. Dispositivo de ajuste (×2)
1C5-9-60-08 9/12/03 8:38 PM Page 8-56