engine coolant YAMAHA GRIZZLY 700 2020 User Guide
[x] Cancel search | Manufacturer: YAMAHA, Model Year: 2020, Model line: GRIZZLY 700, Model: YAMAHA GRIZZLY 700 2020Pages: 182, PDF Size: 7.18 MB
Page 135 of 182

9-32
9
EBU34213To change the coolant
WARNING
EWB01891Wait for the engine and radiator to cool before
removing the radiator cap. You could be
burned by hot fluid and steam blown out under
pressure. Always place a thick rag over the cap
when opening. Allow any remaining pressure
to escape before completely removing the cap. 1. Park the ATV on a level surface.
2. Remove panels A, B, C, and D. (See page9-10.)
3. Remove the footboard by removing the bolts and nuts. 4. Remove the radiator cap.
1. Footboard
2. Bolt and nut
3. Bolt
3
2
2
3
1
UBDE60E0.book  Page 32  Monday, April 22, 2019  4:12 PM 
Page 136 of 182

9-33
95. Place a container under the engine, and then
remove the coolant drain bolt and its gasket.
(Use a trough or a similar object as shown to
prevent coolant from spilling on the engine
guard.)
1. Radiator cap
1
1. Coolant drain bolt
2. Gasket
1. Trough
1
2
1
UBDE60E0.book  Page 33  Monday, April 22, 2019  4:12 PM 
Page 138 of 182

9-35
915. When coolant begins to flow out of the bolt
hole, tighten the water pump air bleed bolt to
the specified torque.
16. Remove panel E. (See page 9-10.)
17. Loosen the clamp screw, and then remove the V-belt cooling duct. 18. Loosen the cylinder head air bleed bolt, with-
out removing it, to allow all of the air to es-
cape from the air bleed bolt hole.
19. When coolant begins to flow out of the bolt hole, tighten the cylinder head air bleed bolt
to the specified torque.
20. Start the engine and let it idle for ten minutes.
21. Rev the engine five times.
Tightening torque:
Water pump air bleed bolt:10 N·m (1.0 kgf·m, 7.4 lb·ft)
1. V-belt cooling duct
2. Clamp screw
1
2
1. Cylinder head air bleed boltTightening torque:Cylinder head air bleed bolt:10 N·m (1.0 kgf·m, 7.4 lb·ft)
1
UBDE60E0.book  Page 35  Monday, April 22, 2019  4:12 PM 
Page 139 of 182

9-36
9
22. Pour additional coolant into the radiator until
it is full.
23. Stop the engine and allow it to cool. If the coolant level has dropped after the engine
has cooled, add sufficient coolant until it
reaches the top of the radiator, and then in-
stall the radiator cap.
24. Start the engine, and then check for coolant leakage.
TIPIf any leakage is found, have a Yamaha dealer
check the cooling system. 25. Install the V-belt cooling duct, and then tight-en the clamp screw.
26. Install the footboard by installing the bolts and nuts, and then tighten them to the speci-
fied torques.
TIPTighten footboard bolts B in the order shown. 1. Footboard nut
2. Footboard bolt A
3. Footboard bolt B
3
1
2
1
UBDE60E0.book  Page 36  Monday, April 22, 2019  4:12 PM 
Page 168 of 182

9-65
9Engine overheating
WARNING
EWB02291Wait for the engine and radiator to cool before removing the radiator cap. You could be burned by
hot fluid and steam blown out under pressure. Always put a thick rag over the cap when opening.
Allow any remaining pressure to escape before completely removing the cap. TIP
Tap water can be used in an emergency. Change to the recommended coolant as soon as possible.
 The engine will tend to overheat if the radiator is caked with mud, or if the ATV is overloaded. Wait until the 
engine has cooled.
Check the coolant level in the 
reservoir and radiator.
The coolant level 
is OK.The coolant level is low.
Check the cooling system
for leakage.
Have a Yamaha dealer check
and repair the cooling system.Add coolant. (See TIP.)
Start the engine. If the engine overheats again, have a 
Yamaha dealer check and repair the cooling system.
There is
leakage.
There is 
no leakage.
UBDE60E0.book  Page 65  Monday, April 22, 2019  4:12 PM 
Page 176 of 182

11-5
11
Spring:Coil spring
Shock absorber: Hydraulic damper
Wheel travel:
193 mm (7.6 in)Rear suspension:Type:Double wishbone
Spring:
Coil spring
Shock absorber: Hydraulic damper
Wheel travel: 232 mm (9.1 in)Electrical system:System voltage:12 V
Ignition system: TCI
Charging system:
AC magnetoBattery:Model:YTX20L-BS
Voltage, capacity:
12 V, 18.0 AhLights:Headlight:LED Handlebar-mounted light:
T15H, 35.0 W/36.5 W
Brake/tail light: LED
Meter lighting:
LED
Neutral indicator light: LED
High beam indicator light: LED
Reverse indicator light:
LED
Coolant temperature warning light: LED
Park indicator light: LED
Engine trouble warning light:
LED
High-range indicator light: LED
Low-range indicator light: LED
Differential gear lock indicator light:
LED
EPS warning light: LED
Battery voltage warning light: LED
Fuses:Main fuse:40.0 A
UBDE60E0.book  Page 5  Monday, April 22, 2019  4:12 PM 
Page 179 of 182

13-1
13
INDEX
AAccessories and loading ................................................ 7-5
Accessories, DC jack  ................................................... 5-29
Air filter element, cleaning  ........................................... 9-37
Axle boots  .................................................................... 9-48BBattery ......................................................................... 9-52
Battery voltage warning light  ......................................... 5-3
Brake fluid, changing  ................................................... 9-45
Brake fluid level, checking  ........................................... 9-44
Brake lever, front  ......................................................... 5-17
Brake levers, checking and lubricating  ........................ 9-49
Brake pads, checking the front and rear  ..................... 9-43
Brake pedal and rear brake lever ................................. 5-17
Brake pedal, checking and lubricating  ........................ 9-50
Brake pedal free play, adjusting  .................................. 9-47
Brakes .......................................................................... 9-42
Brakes, front and rear  .................................................... 6-3
Brake/tail light  .............................................................. 9-61CCables, checking and lubricating  ................................ 9-49
Carrier, front ................................................................. 5-26
Carrier, rear  .................................................................. 5-26
Chassis fasteners  .......................................................... 6-8
Cleaning ....................................................................... 10-1
Coolant .................................................................6-3, 9-29
Coolant temperature warning light  ................................ 5-3DDifferential gear oil  ................................................6-3, 9-27Drive select lever  ......................................................... 5-18
Drive select lever and driving in reverse  ........................ 7-2
EEmissions Certification label (for
 Europe)  .................... 12-1
Engine break-in .............................................................. 7-4
Engine oil  ....................................................................... 6-3
Engine oil and oil filter cartridge  .................................. 9-20
Engine stop switch  ...................................................... 5-11
Engine trouble warning light  .......................................... 5-3
EPS warning light  .......................................................... 5-4FFinal gear oil  ......................................................... 6-3, 9-25
Four-wheel drive/differential gear lock icon  .................. 5-4
Four-wheel drive switch (On-Command 4WD)  ............ 5-13
Front and rear brake lever free play, checking  ............ 9-46
Fuel ....................................................................... 5-20, 6-3
Fuel tank cap  ............................................................... 5-19
Fuses, replacing  .......................................................... 9-56HHandlebar switches  ..................................................... 5-11
Headlight beam, adjusting  ........................................... 9-60
Headlight bulb, replacing ............................................. 9-58
High beam indicator light ............................................... 5-2
High-range indicator light  .............................................. 5-2
Horn switch .................................................................. 5-12IIdentification numbers  ................................................... 1-1
Indicator lights and warning lights  ................................. 5-2
Instruments, lights and switches  ................................... 6-8
UBDE60E0.book  Page 1  Monday, April 22, 2019  4:12 PM