low beam YAMAHA KODIAK 450 2005 Manuale de Empleo (in Spanish)

Adjusting the rear brake lever and
brake pedal .................................... 8-105
Adjusting the rear brake light
switch ............................................. 8-109
Cable inspection and lubrication ...... 8-111
Lubricating the brake levers and
brake pedal .................................... 8-113
Rear knuckle upper and lower
pivot lubrication .............................. 8-115
Wheel removal ................................. 8-115
Wheel installation ............................. 8-117
Battery .............................................. 8-119
Battery maintenance ........................ 8-123
Fuse replacement............................. 8-125
Replacing a headlight bulb ............... 8-129
Headlight beam adjustment.............. 8-133
Tail/brake light bulb replacement ..... 8-133
Troubleshooting................................ 8-137
Troubleshooting chart....................... 8-139
CLEANING AND STORAGE .................. 9-1
A. Cleaning ........................................... 9-1
B. Storage ............................................ 9-7
SPECIFICATIONS ................................ 10-1
910
CONVERSION TABLE .......................... 11-1
11
U1D960.book Page 3 Wednesday, June 23, 2004 3:59 PM

4-17 1. Light switch “//OFF”
2. Start switch “”
3. Engine stop switch “/”
4. Override switch “OVERRIDE”
5. Horn switch “”
1. Contacteur d’éclairage “//OFF”
2. Contacteur du démarreur “”
3. Coupe-circuit du moteur “/”
4. Contacteur de désactivation “OVERRIDE”
5. Contacteur de l’avertisseur “”
1. Interruptor de las luces “//OFF”
2. Interruptor de arranque “”
3. Interruptor de paro del motor “/”
4. Interruptor de cancelación “OVERRIDE”
5. Interruptor de la bocina “”
EBU00053
Handlebar switches
EBU12040
Light switch “/ /OFF”
Set the switch to “” to turn on the low beam and
the taillight.
Set the switch to “” to turn on the high beam
and the taillight.
Set the switch to “OFF” to turn off all the lights.CAUTION:_ Do not use the headlights with the engine
turned off for more than thirty minutes. The
battery may discharge to the point that the
starter motor will not operate properly. If this
should happen, remove the battery and re-
charge it. _
EBU12050
Engine stop switch “/”
Make sure that the engine stop switch is set to
“” before starting the engine. The engine stop
switch controls ignition and can be used at all
times to stop the engine, especially in an emer-
gency. The engine will not start or run when the
engine stop switch is set to “”.
U1D960.book Page 17 Wednesday, June 23, 2004 3:59 PM

8-133 1. Headlight beam adjusting screw
1. Vis de réglage du faisceau de phare
1. Tornillo de ajuste de la luz del faro
1. Tail/brake light unit 2. Nut (× 2)
1. Bloc du feu arrière/stop 2.Écrou (× 2)
1. Unidad de la luz de cola/freno 2. Tuerca (× 2)
EBU01089
Headlight beam adjustmentCAUTION:_ It is advisable to have a Yamaha dealer make
this adjustment. _To raise the beam, turn the adjusting screw in di-
rection
a.
To lower the beam, turn the adjusting screw in di-
rection
b.
EBU09640
Tail/brake light bulb replacement
1. Remove the nuts together with the washers.
U1D960.book Page 133 Wednesday, June 23, 2004 3:59 PM