1
2
3
4
5
6
7
8
9
10
DESCRIPTION
EAU10420
Right view
2-2
10. Grab bar
11. Fuse box (page 6-32)
12. Rear brake fluid reservoir (page 6-21)
13. Front brake fluid reservoir (page 6-21)
14. Coolant reservoir (page 6-12)15. Engine oil filler cap/dipstick (page 6-8)
16. Coolant drain bolt (page 6-12)
17. Engine oil filter element (page 6-10)
18. Shock absorber assembly spring preload adjusting ring (page 3-16)
19. Brake pedal (page 3-11)
MY03 01-03 ING 6-10-2005 13:56 Pagina 13
PERIODIC MAINTENANCE AND MINOR REPAIR
EAUB1350
Engine oil and oil filter
element
The engine oil level should be checked
before each ride. In addition, the oil must
be changed and the oil filter element re-
placed at the intervals specified in the pe-
riodic maintenance and lubrication chart.To check the engine oil level
1. Place the vehicle on a level surface
and hold it in an upright position.NOTE:
Make sure that the vehicle is posi-
tioned straight up when checking the
oil level. A slight tilt to the side can re-
sult in a false reading.
2. Start the engine, warm it up for
10-15 minutes, let it continue to
idle for 20-30 seconds, and then
turn it off.
3. Wait a few minutes until the oil
settles, remove the oil filler cap,
wipe the dipstick clean, insert it
back into the oil filler hole (without
screwing it in), and then remove it
again to check the oil level.
1. Engine oil filler cap
2. Maximum level mark
3. Minimum level mark
EWAB0010
WARNING0
The exhaust pipes are very hot dur-
ing and following operation. To pre-
vent burns when removing the oil
filler cap, use extra care not to
touch the exhaust pipes.
NOTE:
The engine oil tank is located in
front of the frame.
The engine oil should be between
the minimum and maximum level
marks.
6-8
1
2
3
4
5
6
7
8
9
10
MY03 04-06 ING 6-10-2005 9:24 Pagina 6-8
