low beam YAMAHA RHINO 660 2007 Manuale de Empleo (in Spanish)

Cable inspection and lubrication ...... 8-103
Brake pedal and accelerator pedal
lubrication ....................................... 8-105
Rear knuckle upper and lower pivot
lubrication ....................................... 8-105
Steering shaft lubrication .................. 8-107
Wheel removal ................................. 8-107
Wheel installation ............................. 8-109
Battery .............................................. 8-111
Battery maintenance ........................ 8-115
Fuse replacement............................. 8-117
Replacing a headlight bulb ............... 8-123
Headlight beam adjustment.............. 8-129
Tail/brake light bulb replacement ..... 8-131
Troubleshooting................................ 8-137
Troubleshooting charts ..................... 8-139
CLEANING AND STORAGE ................... 9-1
A. Cleaning ........................................... 9-1
B. Storage ............................................ 9-7
SPECIFICATIONS ................................ 10-1
910EE.book Page 3 Friday, October 6, 2006 3:36 PM

4-21 1. Light switch “OFF/ /”
1. Contacteur d’éclairage “OFF/ /”
1. Interruptor de luces “OFF/ /”
L
H
L
H
L
H
EVU00230
Switches
EVU00240
Light switch “OFF/ /”
Set the switch to “” to turn on the low beam and
the taillights.
Set the switch to “” to turn on the high beam
and the taillights.
Set the switch to “OFF” to turn off all the lights.CAUTION:_ Do not use the headlights with the engine
turned off for an extended period of time. The
battery may discharge to the point that the
starter motor will not operate properly. If this
should happen, remove the battery and re-
charge it. _
L
H
LH
EE.book Page 21 Friday, October 6, 2006 3:36 PM

8-129 1. Headlight beam adjusting screw
1. Vis de réglage du faisceau de phare
1. Tornillo de ajuste de la luz del faro
EVU00990
Headlight beam adjustmentCAUTION:_ It is advisable to have a Yamaha dealer make
this adjustment. _To raise the beam, turn the adjusting screw in di-
rection a.
To lower the beam, turn the adjusting screw in di-
rection b.
EE.book Page 129 Friday, October 6, 2006 3:36 PM