belt YAMAHA RHINO 700 2010 Owner's Guide

7-15 1. Latch plate (× 2) 2. Seat belt (× 2)
3. Buckle (× 2)
1. Attache (× 2) 2. Ceinture de sécurité (× 2)
3. Boucle (× 2)
1. Hebilla (× 2) 2. Cinturón de seguridad (× 2)
3. Cierre (× 2)
12
3
1. Latch plate (× 2) 2. Seat belt (× 2)
3. Buckle (× 2)
1. Attache (× 2) 2. Ceinture de sécurité (× 2)
3. Boucle (× 2)
1. Hebilla (× 2) 2. Cinturón de seguridad (× 2)
3. Cierre (× 2)
1
2
3
Seat belts
Seat belts should be worn by the driver and every
passenger. Driver must be sure that every passen-
ger is belted before driving.

Be sure the seat belt is not twisted, is close-
fitting across the hips and chest, and is
latched securely.


Do not wear the lap belt across the abdomen
or stomach.


Do not put the shoulder belt behind the back.
Failure to use seat belts properly may lead to an
increased likelihood and severity of injury.
An unbelted occupant may strike the interior of the
vehicle, the protective structure, or other objects in
an accident or during operation. You may also fall
completely out or be partially ejected from the ve-
hicle, which may lead to being crushed between
the ground and the vehicle. Wearing the seat belt
helps you remain in the vehicle – the doors and
handholds are not a substitute for using a seat
belt.
EE.book Page 15 Monday, January 19, 2009 5:30 PM

7-17
A crash can damage the restraint systems in your
vehicle. A damaged restraint system may not
properly protect the person using it, resulting in se-
rious injury or death in a crash. To help make sure
your restraint systems are working properly after a
crash, have them inspected and any necessary re-
placements made as soon as possible.
To wear the seat belt properly, do the following:
1. Hold the latch plate as you pull the belt
across your lap and chest. Make sure the belt
is not twisted and is not caught on any portion
of the vehicle, your clothing, or any equip-
ment you are carrying.
2. If the latch plate is not positioned in the cor-
rect location along the seat belt, squeeze the
latch plate ends together along its long edges
in order to more easily adjust its location up
or down along the length of the belt.
EE.book Page 17 Monday, January 19, 2009 5:30 PM

7-19 1. Buckle 2. Latch plate 3. Release button
1. Boucle 2. Attache 3. Bouton de déblocage
1. Hebilla 2. Fijación3.Botón de desbloqueo
1
3
2
1. Seat belt height adjuster 2. Seat belt 3. Slot
1. Dispositif de règlement de hauteur de ceinture de sécurité
2. Ceinture de sécurité3. Fente
1. Regulador de altura del cinturón de seguridad
2. Cinturón de seguridad 3. Ranura
1
2
3
3. Push the latch plate into the buckle until it
clicks. Pull up on the latch plate to make sure
it is secure.
4. Put the lap portion of the belt low on your
hips. Pull up on the shoulder part so the belt
is snug across your hips. Be sure the seat
belt is not caught on the hip restraint or other
object.
5. Position the shoulder belt over your shoulder
and across your chest. The shoulder belt
should fit against your chest. If it is loose, pull
the belt out all the way and then let it retract.
6. Check if the seat belt shoulder position suits
the size of the driver and passengers.
To lower the belt, insert the belt into the seat
belt height adjuster slot as shown. To raise
the belt, remove the belt from the height ad-
juster slot.
7. To release the buckle, firmly press the re-
lease button.
EE.book Page 19 Monday, January 19, 2009 5:30 PM

7-63
NOTICEAfter driving your vehicle in water, be sure to
drain the trapped water by removing the check
hoses at the bottom of the air filter case and air
intake duct, the V-belt cooling duct check
hose, the drive select lever box check hose
and the V-belt case drain plug. Wash the vehi-
cle in fresh water if it has been operated in salt
water or muddy conditions.
EE.book Page 63 Monday, January 19, 2009 5:30 PM

8-8
EVU01650
General maintenance and lubrication chart
ITEM ROUTINEWhichever
comes firstINITIAL EVERY
month136612
km
(mi)320
(200)1,200
(750)2,400
(1,500)2,400
(1,500)4,800
(3,000)
hours 20 75 150 150 300
Cooling system*Check coolant leakage.
Repair if necessary.
Replace coolant every 24 months.
Air filter elementClean.
Replace if necessary.Every 20–40 hours
(More often in wet or dusty areas.)
Engine oilReplace (warm engine before draining).Engine oil filter cartridgeReplace.Front differential gear oil
Check oil level/oil leakage.
Replace.Rear differential gear oil
Front brake*Check operation/brake pad wear/fluid leakage/see page 8-9.
Correct if necessary. Replace pads if worn to the limit.Rear brake*Check operation/brake pad wear/fluid leakage/see page 8-9.
Correct if necessary. Replace pads if worn to the limit.Parking brake*Check operation and free play/brake pad wear.
Correct if necessary. Replace pads if worn to the limit.Accelerator pedal*Check operation and free play.V-belt*Check operation.
Check for wear, cracks, or damage.Wheels*Check balance/damage/runout.
Repair if necessary.Wheel bearings*Check bearing assemblies for looseness/damage.
Replace if damaged.Front and rear
suspension*Check operation and for leakage.
Correct if necessary.Steering system*Check operation and for looseness/Replace if damaged.
Check toe-in/Adjust if necessary.Rear upper and lower
knuckle pivots*Lubricate with lithium-soap-based grease.
EE.book Page 8 Monday, January 19, 2009 5:30 PM

8-23 1. Console
1. Console
1. Consola
1
To install
1. Place the console in its original position.
2. Install the quick fastener screws.
3. Install the parking brake lever boot.NOTICE

Be sure to position the seat belt buckles to
the outside of the console.


When installing the console, be sure not to
pinch the cables or wires.


Make sure that the groove at the bottom of
the parking brake lever boot fits securely
around the edge of the hole in the console.
EE.book Page 23 Monday, January 19, 2009 5:30 PM

8-77 1. Side panel 2. Bolt
1. Cache latéral 2. Vis
1. Panel lateral 2. Perno
1
2
1. V-belt cooling duct check hose
1. Tube de vidange du conduit de refroidissement de la courroie trapé-
zoïdale
1. Manguera de comprobación del conducto de enfriamiento de
la correa trapezoidal
1
V-belt cooling duct check hose and V-belt case
drain plug
The V-belt cooling duct check hose and V-belt
case drain plug are located behind the side panel.
1. Open the left front door. (See page 4-47.)
2. Remove the bolt, and then remove the side
panel by pulling it outward.
3. Check the V-belt cooling duct check hose. If
dust or water has collected in the check hose,
remove the hose and clean it.
EE.book Page 77 Monday, January 19, 2009 5:30 PM

8-79 1. V-belt case drain plug
1. Bouchon de vidange du carter de courroie trapézoïdale
1. Tapón de drenaje de la caja de la correa trapezoidal
1
1. Side panel
1. Cache latéral
1. Panel lateral
1
4. Remove the V-belt case drain plug. If water
drains from the V-belt case, have a Yamaha
dealer inspect the vehicle, as the water may
affect other engine parts.
5. Place the side panel in the original position as
shown.
6. Install the bolt, and then tighten it to the spec-
ified torque.
7. Close the door.Tightening torque:
Side panel bolt:
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
EE.book Page 79 Monday, January 19, 2009 5:30 PM

10-5
Transmission:
Primary reduction system V-belt
Secondary reduction system Shaft drive
Secondary reduction ratio 46/22 × 24/18 × 41/9 (12.700)
Transmission type V-belt automatic
Operation Right hand operation
Reverse gear 23/14 × 28/23 (2.000)
Sub transmission ratio low 35/17 (2.059)
high 38/26 (1.462)
Chassis:
Frame type Steel tube frame
Caster angle 3.9°
Trail 20.0 mm (0.79 in)
Tire:
Ty p e Tu b e l e s s
Size front 26
× 9-14NHS
rear 26 × 11-14NHS
Wheel:
Type Panel wheel
Rim size front 14 × 6.5AT
rear 14 × 8.0AT Model YXR7F4PZ
EE.book Page 5 Monday, January 19, 2009 5:30 PM

10-7
Bulb voltage, wattage × quantity:
Headlight 12 V 35.0 W/35.0 W × 2
Tail/brake light 12 V 5.0 W/21.0 W × 2
Indicator lights:
Neutral indicator light LED
Reverse indicator light LED
Coolant temperature warning light LED
Engine trouble warning light LED
EPS warning light LED
Parking brake indicator light LED
On-Command drive indicators LCD
On-Command differential gear lock indicator light LED
High-range indicator light LED
Low-range indicator light LED
Helmet/seat belt indicator light 12 V 0.7 W × 2 Model YXR7F4PZ
EE.book Page 7 Monday, January 19, 2009 5:30 PM