remove seats YAMAHA RHINO 700 2013 Owners Manual

4-18
EVU00330Seats
To remove a seat, pull its seat lock lever up-
ward, lift the front of the seat, and then slide
the seat forward and up.1. Driver seat2. Passenger seat
3. Seat lock lever ( × 2)
To install a seat, insert the projections on the
rear of the seat into the seat holders and push
down on the seat at the front. Make sure the
seats are securely latched. WARNING! A
loose seat could cause the operator to
lose control, or cause the operator or pas-
senger to fall.
1
3
1RB7A_EE.book Page 18 Tuesday, April 24, 2012 9:07 AM

8-9
5B410011Console
To remove1. Remove the seats. (See page 4-18 for seat removal and installation proce-
dures.)
2. Remove the parking brake lever boot.
3. Pull the console forward and upward (the drive select lever boot will come loose).
To ease removal of the console, shift the
drive select lever into the low gear “L” po-
sition.1. Console
To install
1. Place the console in its original position.
2. Install the parking brake lever boot.
3. Install the seats.NOTICE●
Be sure to position the seat belt buck-
les to the outside of the console.
●
When installing the console, be sure
not to pinch the cables or wires.
●
Make sure that the groove at the bot-
tom of the parking brake lever boot
and the drive select lever boot fits se-
curely around the edge of the hole in
the console.
1
1RB7A_EE.book Page 9 Tuesday, April 24, 2012 9:07 AM

8-38
EVU01220Checking the brake pedal
Have a Yamaha dealer check the brakes at
the intervals specified in the periodic mainte-
nance and lubrication chart. There should be
no free play in the brake pedal. The brakes
should operate smoothly and there should be
no brake drag. If the brakes feel soft or
spongy, this could indicate air in the brake
system. Have a Yamaha dealer check the
brake system if necessary.1. Brake pedala. No brake pedal free play
EVU00870Parking brake lever free play adjustment
Periodically check the parking brake lever free
play and adjust it if necessary.
1. Shift the drive select lever into low gear “L”.
2. Remove the seats. (See page 4-18 for
seat removal and installation proce-
dures.)
3. Remove the console. (See page 8-9 for
console removal and installation proce-
dures.)
4. Check the parking brake lever free play.
The maximum free play is equal to one
click of the parking brake lever. If neces-
sary, adjust the free play as follows.
1
a
1RB7A_EE.book Page 38 Tuesday, April 24, 2012 9:07 AM