tow bar YAMAHA SLIDER 50 2005 Owners Manual
[x] Cancel search | Manufacturer: YAMAHA, Model Year: 2005, Model line: SLIDER 50, Model: YAMAHA SLIDER 50 2005Pages: 80, PDF Size: 2.06 MB
Page 21 of 80
INSTRUMENT AND CONTROL FUNCTIONS
3
12
3
ZAUM0142
1
ZAUM0473
1
ZAUM0084
1. Horn switch “
”
2. Turn signal switch “
”
3. Dimmer switch “
,
”1. Start switch “
”1. Front brake lever
EAU00118
Handlebar switches
EAU00125
Turn signal switch “
”
To signal a right-hand turn, push this
switch to the right. To signal a left-hand
turn, push this switch to the left. When
released, the switch returns to the
center position. To cancel the turn si-
gnal lights, push the switch in after it
has returned to the center position.
EAU00129
Horn switch “
”
Press this switch to sound the horn.
EAU03888
Dimmer switch “
,
”
Set this switch to “
” for the high beam
and to “
” for the low beam.
EAUM0063
Start switch “
”
Push this switch while applying the front
or rear brake to crank the engine with
the starter.
EC000005
See page 5-1 for starting instruc-tions prior to starting the engine.
EAU03882
Front brake leverThe front brake lever is located on the
right handlebar grip. To apply the front
brake, pull this lever toward the
handlebar grip.
3-4
Page 22 of 80
3
INSTRUMENT AND CONTROL FUNCTIONS
1
ZAUM0085
2 1
ZAUM0144
EAU00163
Rear brake leverThe rear brake lever is located on the
left handlebar grip. To apply the rear
brake, pull this lever toward the
handlebar grip.1. Rear brake lever
EAU03463
Fuel and 2-stroke engine oil
tank capsThe fuel tank cap and the 2-stroke
engine oil tank cap are located under
the seat. (See page 3-8 for seat
opening and closing procedures.)
Fuel tank cap
To remove the fuel tank cap, turn it
counterclockwise, and then pull it off.
To install the fuel tank cap, turn it
clockwise.2-stroke engine oil tank cap
To remove the 2-stroke engine oil tank
cap, pull it off.
To install the 2-stroke engine oil tank
cap, push it into the oil tank opening.
EW000025
Make sure that the fuel and 2-stroke
engine oil tank caps are properlyinstalled before riding the scooter.
1. Fuel tank cap
2. Oil tank cap
3-5
Page 33 of 80
OPERATION AND IMPORTANT RIDING POINTS
5
ZAUM0525
EAU00433
Starting offNOTE :
Before starting off, allow the engine towarm up.
1. While pulling the rear brake lever
with your left hand and holding the
grab bar with your right hand,
push the scooter off the
centerstand.
2. Sit astride the seat, and then
adjust the rear view mirrors.
3. Switch the turn signal on.
4. Check for oncoming traffic, and
then slowly turn the throttle grip
(on the right) in order to take off.
5. Switch the turn signal off.
EAU01258
Starting a warm engineFollow the same procedure as for
starting a cold engine with the excep-
tion that the starter (choke) is not
required when the engine is warm.
ECA00045
For maximum engine life, never
accelerate hard when the engine iscold!
5. When the engine is warm, turn the
starter (choke) off.NOTE :
The engine is warm when it responds
normally to the throttle with the starter(choke) turned off.
5-2
EC000046
See page 5-4 for engine break-in ins-
tructions prior to operating thevehicle for the first time.