brake YAMAHA SLIDER 50 2007 User Guide

OPERATION AND IMPORTANT RIDING POINTS
5
EAU00434
Acceleration and
decelerationThe speed can be adjusted by opening
and closing the throttle. To increase the
speed, turn the throttle grip in direction
a . To reduce the speed, turn the
throttle grip in direction b .
a b
ZAUM0199
cdds
ZAUM0526
EAU00435
Braking1. Close the throttle completely.
2. Apply both front and rear brakes
simultaneously while gradually
increasing the pressure.
EW000057
•
Avoid braking hard or suddenly
(especially when leaning over
to one side), otherwise the
scooter may skid or overturn.
•
Railroad crossings, streetcar
rails, iron plates on road cons-
truction sites, and manhole
covers become extremely
slippery when wet. Therefore,
slow down when approaching
such areas and cross them with
caution.
•
Keep in mind that braking on a
wet road is much more difficult.
•
Ride slowly down a hill, as
braking downhill can be verydifficult.
5-3

EAU00462
PERIODIC MAINTENANCE AND MINOR REPAIR
Periodic maintenance and lubrication chart ............ 6-2
Checking the spark plug ......................................... 6-5
Final transmission oil .............................................. 6-6
Cleaning the air filter element ................................. 6-7
Adjusting the carburetor .......................................... 6-8
Adjusting the throttle cable free play ....................... 6-8
Tires ........................................................................ 6-9
Cast wheels .......................................................... 6-11
Adjusting the front brake lever free play ............... 6-11
Adjusting the rear brake lever free play ................ 6-11
Checking the front brake pads
and rear brake shoes ............................................ 6-12
Checking the brake fluid level ............................... 6-13
Changing the brake fluid ....................................... 6-14
Checking and lubricating the cables ..................... 6-14
6 Checking and lubricating the throttle grip
and cable .............................................................. 6-15
Lubricating the front and rear brake levers ........... 6-15
Checking and lubricating the centerstand ............. 6-15
Checking the front fork .......................................... 6-16
Checking the steering ........................................... 6-16
Checking the wheel bearings ................................ 6-17
Battery ................................................................... 6-17
Replacing the fuse ................................................ 6-19
Replacing a headlight bulb .................................... 6-20
Replacing a front turn signal light bulb .................. 6-21
Replacing a rear turn signal light bulb or
the tail/brake light bulb .......................................... 6-21
Troubleshooting .................................................... 6-21
Troubleshooting chart ........................................... 6-22

PERIODIC MAINTENANCE AND MINOR REPAIR
6
EAU03686
Periodic maintenance and lubrication chartNOTE :•
The annual checks must be performed every year, except if a kilometer-based maintenance is performed instead.
•
From 30,000 km, repeat the maintenance intervals starting from 6,000 km.
•
Items marked with an asterisk should be performed by a Yamaha dealer as they require special tools, data and technical skills.
1 * Fuel line•Check fuel hoses and vacuum hose for cracks or damage.√√√√ √2 Spark plug•Replace.√√√√ √3 Air filter element•Clean.√√
•Replace.√√
4 * Battery•Check electrolyte level and specific gravity.
√√√√ √•Make sure that the breather hose is properly routed.
•Check operation, fluid level and vehicle for fluid leakage.
√√√√√ √
5 * Front brake(See NOTE on page 6-4.)
•Replace brake pads.Whenever worn to the limit
6 * Rear brake•Check operation and adjust brake lever freeplay.√√√√√ √
•Replace brake shoes.Whenever worn to the limit
7 * Brake hose•Check for cracks or damage.√√√√ √
•Replace. (See NOTE on page 6-4.)Every 4 years
8 * Wheels•Check runout and for damage.√√√√
ODOMETER READING (x 1,000 km)
NO. ItemCheck or maintenance job1
ANNUAL
CHECK
6121824
6-2

PERIODIC MAINTENANCE AND MINOR REPAIR
6
6-4 20 * Front and rear
•Check operation.√√√√√ √
brake switches
21 Moving parts and cables•Lubricate.√√√√ √
22 * Throttle grip housing and•Check operation and free play.
cable•Adjust the throttle cable free play if necessary.√√√√ √
•Lubricate the throttle grip housing and cable.
23 * Lights, signals and•Check operation.
√√√√√ √
switches•Adjust headlight beam.
NO. Item
Check or maintenance job
ODOMETER READING (x 1,000 km)1ANNUAL
CHECK
6121824
EAU03541*
NOTE :•
The air filter needs more frequent service if you are riding in unusually wet or dusty areas.
•
Hydraulic brake service•Regularly check and, if necessary, correct the brake fluid level.•Every two years change the brake fluid.•Replace the brake hoses every four years and if cracked or damaged.

PERIODIC MAINTENANCE AND MINOR REPAIR
6 Tire inspection
The tires must be checked before each
ride. If the center tread depth reaches
the specified limit, if the tire has a nail
or glass fragments in it, or if the sidewall
is cracked, have a Yamaha dealer re-
place the tire immediately.
EW000079
•
Have a Yamaha dealer replace
excessively worn tires. Besides
being illegal, operating the
scooter with excessively worn
tires decreases riding stability
and can lead to loss of control.
•
The replacement of all wheel
and brake related parts,
including the tires, should be
left to a Yamaha dealer, who has
the necessary professionalknowledge and experience.
Minimum tire tread depth
(front and rear)1.6 mmNOTE :
The tire tread depth limits may differ
from country to country. Always complywith the local regulations.
1
2
ZAUM00541. Tread depth
2. Side wall
Tire information
This scooter is equipped with tubeless
tires.
6-10
MICHELIN
120/80-12 55L BOPPER
FrontManufacturer Size TypeRearCHENG SHIN
120/80-12 55J MAXXIS
MICHELIN
130/90-10 61L BOPPER
CHENG SHIN
130/90-10 61J MAXXIS
Manufacturer Size Type

PERIODIC MAINTENANCE AND MINOR REPAIR
6
EAU03773
Cast wheelsTo maximize the performance,
durability, and safe operation of your
scooter, note the following points
regarding the specified wheels.•
The wheel rims should be
checked for cracks, bends or
warpage before each ride. If any
damage is found, have a Yamaha
dealer replace the wheel. Do not
attempt even the smallest repair
to the wheel. A deformed or
cracked wheel must be replaced.
•
The wheel should be balanced
whenever either the tire or wheel
has been changed or replaced. An
unbalanced wheel can result in
poor performance, adverse
handling characteristics, and a
shortened tire life.
•
Ride at moderate speeds after
changing a tire since the tire sur-
face must first be "broken in" for it
to develop its optimal
characteristics.
EAU00697*
Adjusting the front brake
lever free playThe brake lever free play should
measure 10 - 20 mm as shown.
Periodically check the brake lever free
play and, if necessary, have a Yamaha
dealer adjust it.
EW000100
An incorrect brake lever free play
indicates a hazardous condition in
the brake system. Do not operate the
scooter until the brake system has
been checked or repaired by aYamaha dealer.
a
ZAUM0107
aZAUM0108
a. Front brake lever free playa. Rear brake lever free play
EAU04469
Adjusting the rear brake
lever free playThe brake lever free play should
measure 10 - 20 mm as shown.
Periodically check the brake lever free
play and, if necessary, adjust it as
follows.
6-11

PERIODIC MAINTENANCE AND MINOR REPAIR
6
ab
ZAUM0320To increase the brake lever free play,
turn the adjusting nut at the brake shoe
plate in direction a . To decrease the
brake lever free play, turn the adjusting
nut in direction b .
EW000101
If proper adjustment cannot be
obtained as described, have a
Yamaha dealer make thisadjustment.
EAU00720
Checking the front brake
pads and rear brake shoesThe front brake pads and the rear brake
shoes must be checked for wear at the
intervals specified in the periodic main-
tenance and lubrication chart.
EAU01436
Front brake pads
Check each front brake pad for damage
and measure the lining thickness. If a
brake pad is damaged or if the lining
thickness is less than 3.1 mm, have a
Yamaha dealer replace, the brake pads
as a set.
a
ZAUM0243a. Wear limit
6-12

PERIODIC MAINTENANCE AND MINOR REPAIR
6
EAU04502
Rear brake shoes
The rear brake is provided with a wear
indicator, which allows you to check the
brake shoe wear without having to
disassemble the brake. To check the
brake shoe wear, check the position of
the wear indicator while applying the
brake. If a brake shoe has worn to the
point that the wear indicator reaches
the wear limit line, have a Yamaha dea-
ler replace the brake shoes as a set.
1
2
ZAUM00591. Wear indicator
2. Wear limit
1
ZAUM05271. Minimum level mark
6-13
EAU00732
Checking the brake fluid levelInsufficient brake fluid may allow air to
enter the brake system, possibly causing
it to become ineffective.
Before riding, check that the brake fluid
is above the minimum level mark and
replenish if necessary. A low brake fluid
level may indicate worn brake pads and/
or brake system leakage. If the brake
level is low, be sure to check the brake
pads for wear and the brake system for
leakage.Observe these precautions:
•
When checking the fluid level,
make sure that the top of the
master cylinder is level by turning
the handlebars.
•
Use only the recommended quality
brake fluid, otherwise the rubber
seals may deteriorate, causing
leakage and poor braking perfor-
mance.
Recommended brake fluid:
DOT 4
NOTE :
If DOT 4 is not available, DOT 3 can beused.•
Refill with the same type of brake
fluid. Mixing fluids may result in a
harmful chemical reaction and lead
to poor braking performance.
•
Be careful that water does not en-
ter the master cylinder when
refilling. Water will significantly
lower the boiling point of the fluid
and may result in vapor lock.

PERIODIC MAINTENANCE AND MINOR REPAIR
6
EAUM0008
Changing the brake fluidHave a Yamaha dealer change the
brake fluid at the intervals specified in
the periodic maintenance and
lubrication chart. In addition, have the
brake hose replaced every four years
or whenever it is damaged or leaking.
EAU02962
Checking and lubricating the
cablesThe operation of all control cables and
the condition of the cables should be
checked before each ride, and the
cables and cable ends should be
lubricated if necessary. If a cable is
damaged or does not move smoothly,
have a Yamaha dealer check or replace
it.
Recommended lubricant:
Engine oil
EW000112
Damage to the outer sheath may
interfere with proper cable operation
and will cause the inner cable to
rust. Replace a damaged cable as
soon as possible to prevent unsafeconditions.
6-14
•
Brake fluid may deteriorate painted
surfaces or plastic parts. Always
clean up spilled fluid immediately.
•
As the brake pads wear, it is nor-
mal for the brake fluid level to
gradually go down. However, if the
brake fluid level goes down
suddenly, have a Yamaha dealer
check the cause.

PERIODIC MAINTENANCE AND MINOR REPAIR
6
EAU04034
Checking and lubricating the
throttle grip and cableThe operation of the throttle grip should
be checked before each ride. In addi-
tion, the cable should be lubricated or
replaced at the intervals specified in the
periodic maintenance chart.
ZAUM0061
EAU03118
Lubricating the front and rear
brake leversThe pivoting points of the front and rear
brake levers must be lubricated at the
intervals specified in the periodic main-
tenance and lubrication chart.
Recommended lubricant:
Lithium-soap-based grease
(all-purpose grease)
EAU04123
Checking and lubricating the
centerstandThe operation of the centerstand should
be checked before each ride, and the
pivots and metal-to-metal contact sur-
faces should be lubricated if necessary.
EWA00055
If the centerstand does not move up
and down smoothly, have a Yamahadealer check or repair it.
Recommended lubricant:
Lithium-soap-based grease
(all-purpose grease)
1
ZAUM04551. Centerstand
6-15