2. Tire inspection
Always check the tires before operat-
ing the motorcycle. If center tread
depth reaches the limit as shown, if
the tire has a nail or glass fragments
in it, or if the side wall is cracked, con-
tact a Yamaha dealer immediately and
have the tire replaced.wIt is dangerous to ride with a worn-out
tire. When a tire tread begins to show
lines, have a Yamaha dealer replace the
tire immediately. Brakes, tires, and related
wheel parts replacement should be left to
a Yamaha Service Technician.
27
1. Tread depth 2. Side wall 3. Wear indicator
Size
FRONT
2.25-17-4PR
Size
REAR
2.50-17-4PR
Minimum tire tread depth
1.0 mm
(front and rear)
T105(E) O/M-2 9/11/01 11:17 AM Page 27 (1,1)
To decelerate
1. Close the throttle and apply both the
front and the rear brakes at the same
time to slow the motorcycle.
2. Downshift through the gears and
when the motorcycle is almost com-
pletely stopped, shift into nutral.
Recommend shift point:
33
Gear position Recommend speed
4th
3rd 0~40 km/h
3rd 2rd 0~30 km/h
2nd 1st 0~15 km/h
T105(E) O/M-2 9/11/01 11:17 AM Page 33 (1,1)
EAK00000
CLEANING AND
STORAGE
EAK01302*A. CLEANING
Frequent, thorough cleaning of your mo-
torcycle will not only enhance its appear-
ance but will improve its general perfor-
mance and extend the useful life of many
components.
1. Rinse the dirt and degreaser off with a
garden hose.EUU34602cCExcessive hose pressure may cause water
seepage and deterioration of wheel bear-
ings, front fork, brakes, transmission seals
and electrical parts.2. After cleaning the motorcycle, dry all
surfaces with a chamois, clean towel,
or soft absorbent cloth.3. Dry the chain and lubricate it to pre-
vent rust.
4. Automotive-type wax may be applied
to all painted and chrome-plated sur-
faces. When finished, start the engine
and let it idle for several minutes.
EAK00700B. STORAGE
Long term storage (60 days or more) of
your motorcycle will require some preven-
tive procedures to guard against deteriora-
tion. After thoroughly cleaning the motor-
cycle, prepare for storage as follows:
1. Drain the fuel tank, fuel lines, and car-
buretor float bowl(s).
2. Remove the empty fuel tank, pour a
cup of SAE 10W30 or 20W40 motor oil
in the tank, shake the tank to coat the
inner surfaces thoroughly and drain
off the excess oil. Reinstall the tank.
64
T105(E) O/M-3 9/11/01 11:17 AM Page 64 (1,1)
