PERIODIC MAINTENANCE AND MINOR REPAIR
6-34
6 3. Loosen the brake torque rod nut at
the brake shoe plate.
4. Disconnect the brake torque rod
from the brake shoe plate by re-
moving the cotter pin, the nut, the
washer and the bolt.
5. Place the motorcycle on the cen-
terstand.
6. Remove the brake pedal free play
adjusting nut, and then disconnect
the brake rod from the brake cam-
shaft lever.7. Remove the axle nut and the
washer, and then pull the wheel
axle out.
NOTE:Do not remove the washer on the right
side of the wheel axle so as to not loseit.
8. Push the wheel forward, and then
remove the drive chain from the
rear sprocket.
NOTE:The drive chain does not need to be
disassembled in order to remove andinstall the wheel.
9. Remove the wheel.
EAU37751
To install the rear wheel
1. Install the drive chain onto the rear
sprocket.
2. Install the wheel by inserting the
wheel axle from the right-hand
side.NOTE:Make sure the washer is installed onto
the wheel axle before installing thewheel axle.
3. Install the washer and the axle nut.
4. Install the brake rod onto the brake
camshaft lever, and then install the
brake pedal free play adjusting nut
onto the brake rod.
5. Connect the brake torque rod to
the brake shoe plate by installing
the bolt, the washer and the nut.
6. Adjust the drive chain slack. (See
page 6-22.)
1. Brake torque rod
2. Brake torque rod cotter pin
3. Brake torque rod nut and bolt
1. Wheel axle
2. Washer
3. Brake rod
4. Brake pedal free play adjusting nut
5. Brake camshaft lever
U5YPE0E0.book Page 34 Wednesday, February 23, 2005 4:22 PM
