height adjustment YAMAHA TTR125 2000 Notices Demploi (in French)
[x] Cancel search | Manufacturer: YAMAHA, Model Year: 2000, Model line: TTR125, Model: YAMAHA TTR125 2000Pages: 442, PDF Size: 26.34 MB
Page 160 of 442
3 - 16
INSP
ADJBRAKE PEDAL HEIGHT ADJUSTMENT/BRAKE SHOE
INSPECTION/SPROCKETS INSPECTION
BRAKE PEDAL HEIGHT ADJUSTMENT
1. Check:
lBrake pedal height a
Out of specification ® Adjust.
Brake pedal height a:
1 mm (0.04 in)
2. Adjust:
lBrake pedal height
Pedal height adjustment steps:
lLoosen the locknut 1.
lTurn the adjusting bolt 2 until the pedal
height a is within specified height.
lTighten the locknut.
BRAKE SHOE INSPECTION
1. Inspect:
lBrake shoe lining wear limit
Front
õRear
Brake shoe lining wear limit checking
steps:
lFully pull in the brake lever (push down
the pedal) and hold it in position.
lThen check the brake shoe wear indicator
1 is within the wear limit a.
Outside the limit ® Replace the brake
shoe.
Refer to “FRONT WHEEL AND FRONT
BRAKE” or “REAR WHEEL AND REAR
BRAKE” section in the CHAPTER 5.
õ
SPROCKETS INSPECTION
1. Inspect:
lSprocket teeth a
Excessive wear ® Replace.
NOTE:
Replace the drive, driven sprockets and drive
chain as a set.