clutch YAMAHA TW200 2002 Owners Manual

EAU00009
TABLE OF CONTENTS
1
2
3
4
5
6
7
8
9 GIVE SAFETY THE RIGHT OF WAY ..................1-1
DESCRIPTION .....................................................2-1
Left view............................................................2-1
Right view .........................................................2-2
Controls/Instruments .......................................2-3
INSTRUMENT AND CONTROL
FUNCTIONS ........................................................3-1
Main switch/Steering lock ...............................3-1
Indicator lights..................................................3-2
Speedometer ....................................................3-2
Handlebar switches..........................................3-3
Clutch lever .......................................................3-4
Shift pedal.........................................................3-4
Front brake lever ..............................................3-5
Rear brake pedal ..............................................3-5
Fuel tank cap.....................................................3-5
Fuel ....................................................................3-6
Fuel cock ...........................................................3-7
Starter (choke) “1” .........................................3-8
Kick starter ........................................................3-8
Seat ...................................................................3-9
Helmet holder ...................................................3-9
Rear shock absorber ......................................3-10
Rear carrier .....................................................3-10Sidestand ........................................................3-10
Sidestand/clutch switch operation check .....3-11
PRE-OPERATION CHECKS.................................4-1
Pre-operation check list ...................................4-1
OPERATION AND IMPORTANT RIDING
POINTS................................................................5-1
Starting and warming up a cold engine.........5-1
Starting a warm engine ...................................5-4
Shifting..............................................................5-4
Engine break-in ................................................5-5
Parking ..............................................................5-6
PERIODIC MAINTENANCE AND MINOR
REPAIR ................................................................6-1
Tool kit ..............................................................6-1
Periodic maintenance and lubrication............6-3
Cowling and panel removal and
installation ........................................................6-6
Cowling A .........................................................6-6
Panel A ..............................................................6-7
Panel B ..............................................................6-7
Spark plug inspection ......................................6-7
Engine oil ..........................................................6-8
Air filter ...........................................................6-12
1
2
3
4
5
6
5FY-9-E0 (TW200) 7/29/02 10:54 AM Page 5

Carburetor adjustment ..................................6-13
Idle speed adjustment ...................................6-13
Throttle cable free play inspection ...............6-14
Cam chain adjustment ...................................6-14
Valve clearance adjustment ..........................6-14
Tires.................................................................6-15
Wheels ............................................................6-17
Clutch lever free play adjustment .................6-18
Front brake lever free play adjustment ........6-18
Rear brake pedal height and free play
adjustment ......................................................6-19
Brake light switch adjustment.......................6-20
Checking the brake shoes..............................6-21
Drive chain slack check ..................................6-21
Drive chain slack adjustment ........................6-22
Drive chain lubrication...................................6-23
Cable inspection and lubrication ..................6-24
Throttle cable and grip lubrication ...............6-24
Brake and shift pedal lubrication ..................6-24
Brake and clutch lever lubrication ................6-25
Sidestand lubrication .....................................6-25
Rear suspension lubrication..........................6-25
Front fork inspection ......................................6-26
Steering inspection ........................................6-26
Wheel bearings ..............................................6-27
Battery .............................................................6-27Fuse replacement ...........................................6-29
Headlight bulb replacement ..........................6-30
Supporting the motorcycle ...........................6-31
Front wheel removal ......................................6-31
Front wheel installation .................................6-32
Rear wheel removal .......................................6-33
Rear wheel installation ..................................6-33
Troubleshooting .............................................6-34
Troubleshooting chart ...................................6-35
CLEANING AND STORAGE ...............................7-1
Cleaning ............................................................7-1
Storage..............................................................7-2
SPECIFICATIONS................................................8-1
How to use the conversion table ....................8-4
CONSUMER INFORMATION .............................9-1
Identification numbers record.........................9-1
Key identification number ...............................9-1
Vehicle identification number .........................9-1
Model label .......................................................9-2
TABLE OF CONTENTS
1
2
3
4
5
6
7
8
9
7
8
9
5FY-9-E0 (TW200) 7/29/02 10:54 AM Page 6

1
2
3
4
5
6
7
8
9
DESCRIPTION
2-3
13. Clutch lever (page 3-4, 6-18)
14. Left handlebar switches (page 3-3)
15. Speedometer (page 3-2)
16. Right handlebar switches (page 3-3)
17. Front brake lever (page 3-5, 6-18)18. Throttle grip (page 6-14, 6-24)
19. Fuel tank cap (page 3-5)
20. Main switch (page 3-1)
13 14 15 16 17
18
19
20
Controls/Instruments
5FY-9-E0 (TW200) 7/29/02 10:54 AM Page 10

3-4
EAU00141Start switch “START”
The starter motor cranks the
engine when pushing the start
switch.
EC000005
cC
See starting instructions prior to
starting the engine.
INSTRUMENT AND CONTROL FUNCTIONS
1
2
3
4
5
6
7
8
9
EAU00152Clutch lever
The clutch lever is located on the
left handlebar, and the ignition cir-
cuit cut-off system is incorporated
in the clutch lever holder. Pull the
clutch lever to the handlebar to dis-
engage the clutch, and release the
lever to engage the clutch. The
lever should be pulled rapidly and
released slowly for smooth clutch
operation. (Refer to the engine
starting procedures for a descrip-
tion of the ignition circuit cut-off
system.)
1
N5
4
3
2
1
EAU00157
Shift pedal
This motorcycle is equipped with a
constant-mesh 5-speed transmis-
sion.
The shift pedal is located on the
left side of the engine and is used
in combination with the clutch
when shifting.
N. Neutral
1. Shift pedal
5FY-9-E0 (TW200) 7/29/02 10:54 AM Page 14

3-8
INSTRUMENT AND CONTROL FUNCTIONS
1
2
3
4
5
6
7
8
9
ab
1
EAU00210Starter(choke) “1”
Starting a cold engine requires a
richer air-fuel mixture. A separate
starter circuit supplies this mixture.
Move in direction ato turn on the
starter(choke).
Move in direction bto turn off the
starter(choke).
1. Starter (choke) “1”
RES: This indicates reserve. If you
run out of fuel while riding,
set the fuel cock to this posi-
tion.
Fill the tank at the first oppor-
tunity. Be sure to set the fuel
cock back to “ON” after refu-
eling!
OFF
ONFUEL RES
1
RES
1. Arrow mark
RES
EAU00212Kick starter
Rotate the kick starter away from
the engine. Push the starter down
lightly with your foot until the
gears engage, then kick smoothly
and forcefully to start the engine.
This model has a primary-coupled
kick starter so the engine can be
started in any gear if the clutch is
disengaged. However, shifting to
neutral before starting is recom-
mended.
1
1. Kick starter
5FY-9-E0 (TW200) 7/29/02 10:54 AM Page 18

3-11
EW000044
w
This motorcycle must not be oper-
ated with the sidestand in the
down position. If the stand is not
properly retracted, it could contact
the ground and distract the opera-
tor, resulting in a possible loss of
control. Yamaha has designed into
this motorcycle a lockout system
to assist the operator in fulfilling
the responsibility of retracting the
sidestand. Please check carefully
the operating instructions listed
below and if there is any indication
of a malfunction, return the motor-
cycle to a Yamaha dealer immedi-
ately for repair.
INSTRUMENT AND CONTROL FUNCTIONS
1
2
3
4
5
6
7
8
9
EAU00331
Sidestand/clutch switch
operation check
Check the operation of the side-
stand switch and clutch switch
against the information below.
TURN THE MAIN SWITCH TO “ON”
AND THE ENGINE STOP SWITCH TO
“RUN”.
TRANSMISSION IS IN GEAR AND
SIDESTAND IS UP.
PULL IN CLUTCH LEVER AND
PUSH THE START SWITCH.
ENGINE WILL START.
CLUTCH SWITCH IS OK.
EW000045
w
If improper operation is noted,
consult a Yamaha dealer immedi-
ately.
SIDESTAND IS DOWN.
ENGINE WILL STALL.
SIDESTAND SWITCH IS OK.
5FY-9-E0 (TW200) 7/29/02 10:54 AM Page 21

4-1
EAU01114
PRE-OPERATION CHECKS
1
2
3
4
5
6
7
8
9Owners are personally responsible for their vehicle’s condition. Your motorcycle’s vital functions can start to
deteriorate quickly and unexpectedly, even if it remains unused (for instance, if it is exposed to the elements).
Any damage, fluid leak or loss of tire pressure could have serious consequences. Therefore, it is very important
that, in addition to a thorough visual inspection, you check the following points before each ride.
EAU00340PRE-OPERATION CHECK LIST
ITEM CHECKS PAGE
Brakes9Check operation, condition and free play.
3-5, 6-18 ~ 6-21
9Adjust if necessary.
Clutch9Check operation and free play.
3-4, 6-18
9Adjust if necessary.
9Check for smooth operation.
Throttle grip and housing9Lubricate.6-14, 6-24
9Adjust throttle cable free play if necessary.
Engine oil9Check oil level.
6-8 ~ 6-11
9Fill with oil if necessary.
Drive chain9Check chain slack and condition.
6-21 ~ 6-23
9Adjust if necessary.
Wheels and tires9Check tire pressure, wear, damage and spoke tightness.
6-15 ~ 6-17
9Tighten spokes if necessary.
Brake and shift pedal shafts9Check for smooth operation.
6-24
9Lubricate if necessary.
Brake and clutch lever pivots9Check for smooth operation.
6-25
9Lubricate if necessary.
Sidestand pivot9Check for smooth operation.
6-25
9Lubricate if necessary.
Chassis fasteners9Make sure that all nuts, bolts, and screws are properly tightened.
—
9Tighten if necessary.
5FY-9-E0 (TW200) 7/29/02 10:54 AM Page 22

EAU00373
w
1. Before riding this motorcycle,
become thoroughly familiar
with all operating controls and
their functions. Consult a
Yamaha dealer regarding any
control or function that you do
not thoroughly understand.
2. Never start your engine or let
it run for any length of time in
a closed area. The exhaust
fumes are poisonous and can
cause loss of consciousness
and death within a short time.
Always operate your motorcy-
cle in an area with adequate
ventilation.
3. Before starting out, always be
sure the sidestand is up.
Failure to retract the sidestand
completely can result in a seri-
ous accident when you try to
turn a corner.
EAU00411
Starting and warming up a
cold engine
NOTE:
This motorcycle is equipped with a
starting and an ignition circuit cut-
off switch.
1. The engine can be started only
under the following condi-
tions:
a. The transmission is in neutral.
b. The sidestand is up, the trans-
mission is in gear, and the
clutch is disengaged.
2. The motorcycle must not be
ridden when the sidestand is
down.
EW000054
w
Before going through the follow-
ing steps, check the function of the
sidestand switch and clutch
switch. (Refer to page 3-11.)
5-1
EAU00372
OPERATION AND IMPORTANT RIDING POINTS
1
2
3
4
5
6
7
8
9
5FY-9-E0 (TW200) 7/29/02 10:54 AM Page 24

5-2
OPERATION AND IMPORTANT RIDING POINTS
1
2
3
4
5
6
7
8
9
IF TRANSMISSION IS IN NEUTRAL
AND SIDESTAND IS DOWN,
PUSH START SWITCH OR
KICK THE KICK STARTER.
ENGINE WILL START.
RETRACT SIDESTAND AND PUT
TRANSMISSION IN GEAR.
MOTORCYCLE CAN BE RIDDEN.MOTORCYCLE CAN BE RIDDEN.
IF TRANSMISSION IS IN GEAR AND
SIDESTAND IS UP,
PULL IN CLUTCH LEVER AND PUSH START
SWITCH OR KICK THE KICK STARTER.
ENGINE WILL START.
TURN THE MAIN SWITCH TO “ON” AND
THE ENGINE STOP SWITCH TO “RUN”
5FY-9-E0 (TW200) 7/29/02 10:54 AM Page 25

5-4
OPERATION AND IMPORTANT RIDING POINTS
1
2
3
4
5
6
7
8
9
EAU00423
Shifting
The transmission lets you control
the amount of power you have
available at a given speed for start-
ing, accelerating, climbing hills,
etc. The use of the shift pedal is
shown in the illustration.
To shift into neutral, depress the
shift pedal repeatedly until it reach-
es the end of its travel, then raise
the pedal slightly.
EC000048
cC
1. Do not coast for long periods
with the engine off, and do
not tow the motorcycle a long
distance. Even with gears in
neutral, the transmission is
only properly lubricated when
the engine is running.
Inadequate lubrication may
damage the transmission.
2. Always use the clutch when
changing gears. The engine,
transmission, and driveline are
not designed to withstand the
shock of forced shifting and
can be damaged by shifting
without using the clutch.
1
N5
4
3
2
1
N. Neutral
1. Shift pedal
EAU01258Starting a warm engine
The starter (choke) is not required
when the engine is warm.
EC000046
cC
See the “Engine break-in” section
prior to operating the motorcycle
for the first time.
5FY-9-E0 (TW200) 7/29/02 10:54 AM Page 27