6-9
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
1
2. Engine oil replacement
a. Warm up the engine for a few
minutes.
b. Stop the engine. Place an oil
pan under the engine and
remove the oil filler cap.
1. Oil filler cap
2
3 1
b. With the engine stopped,
check the oil level through the
level window located at the
lower part of the right side
crankcase cover.
NOTE:
Wait a few minutes until the oil
level settles before checking.
c. The oil level should be
between the maximum and
minimum marks. If the level is
low, add sufficient oil to raise
it to the proper level.
1. Level window
2. Maximum level mark
3. Minimum level mark
1
c. Remove the drain plug and
drain bolt.
1. Drain plug
5FY-9-E0 (TW200) 7/29/02 10:54 AM Page 38
6-10
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
1 2 3
4
EC000070
cC
When removing the oil drain plug,
the O-ring, compression spring,
and oil strainer will fall out. Take
care not to lose these parts.
NOTE:
The oil filter cover is secured by
two screws and a drain bolt.
Remove the drain bolt to drain the
filter cavity.
1. Drain plug
2. O-ring
3. Compression spring
4. Oil strainer
1
2
d. Remove the filter cover screws
and the oil filter cover.
e. Remove the oil filter element
and O-ring.
f. Clean the oil filter and strainer
with solvent. Replace if neces-
sary.
g. Check the O-rings. If damaged,
replace.
h. Install the drain plug, filter
cover, screws and drain bolt.
Tighten the drain plug to the
specified tightening torque.
1. Filter cover screw (×2)
2. Drain bolt
21
NOTE:
Make sure the O-ring is seated
properly.
EC000071
cC
Before reinstalling the oil drain
plug, do not forget to install the O-
ring, compression spring, and oil
strainer in position.
1. Oil filter
2. O-ring (×2)
5FY-9-E0 (TW200) 7/29/02 10:54 AM Page 39
6-11
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9i. Fill the engine with oil. Install
the oil filler cap and tighten.
EC000066
cC
8Do not put in any chemical
additives. Engine oil also lubri-
cates the clutch and additives
could cause clutch slippage.
8Be sure no foreign material
enters the crankcase.
Recommended oil:
See page 8-1
Oil quantity:
Total amount:
1.3 L
Periodic oil change:
1.0 L
With oil filter replacement:
1.1 LTightening torque:
Drain plug:
10 Nm (1.0 m0kg)
Filter cover screw:
10 Nm (1.0 m0kg)
Drain bolt (filter cover):
10 Nm (1.0 m0kg)j. Start the engine and warm up
for a few minutes. While
warming up, check for oil leak-
age. If oil leakage is found,
stop the engine immediately
and check for the cause.
5FY-9-E0 (TW200) 7/29/02 10:54 AM Page 40
