battery YAMAHA V1 2015 User Guide

Specifications
78
EJU34543
Specifications
Watercraft capacity:
Maximum people on board:
3 person
Maximum load capacity:
240 kg (530 lb)
Dimensions:
Length:
V1 3220 mm (126.8 in)
V1 Sport 3270 mm (128.7 in)
Width:
1170 mm (46.1 in)
Height:
1160 mm (45.7 in)
Dry weight:
V1 334 kg (736 lb)
V1 Sport 338 kg (745 lb)
Performance:
Maximum output (according to ISO 8665/SAE
J1228):
75.0 kW@8000 r/min
Maximum fuel consumption:
25.7 L/h (6.8 US gal/h, 5.7 Imp.gal/h)
Cruising range at full throttle:
2.73 hour
Trolling speed:
1650 ±50 r/min
Engine:
Engine type:
Liquid cooled 4-stroke, DOHC
Number of cylinders:
4
Engine displacement:
1052 cm³
Bore × stroke:
76.0 × 58.0 mm (2.99 × 2.28 in)
Compression ratio:
11.4 : 1
Valve clearance-intake (cold):
0.11–0.20 mm (0.0043–0.0079 in)
Valve clearance-exhaust (cold):
0.25–0.34 mm (0.0098–0.0134 in)
Lubrication system:
Dry sump
Cooling system:
Water
Starting system:
ElectricIgnition system:
T.C.I.
Spark plug:
CR9EB
Spark plug gap:
0.7–0.8 mm (0.028–0.031 in)
Battery capacity:
12 V, 19 Ah
Charging system:
Flywheel magneto
Drive unit:
Propulsion system:
Jet pump
Jet pump type:
Axial flow, single stage
Impeller rotation:
Counterclockwise
Jet thrust nozzle angle:
24.0+24.0 °
Fuel and oil:
Recommended fuel:
Regular unleaded gasoline
Minimum octane rating (PON):
86
Minimum octane rating (RON):
90
Recommended engine oil type SAE:
SAE 10W-30, 10W-40, 20W-40, 20W-50
Recommended engine oil grade API:
API SE,SF,SG,SH,SJ,SL
Fuel tank total capacity:
70 L (18.5 US gal, 15.4 Imp.gal)
Engine oil quantity with oil filter replacement:
2.2 L (2.33 US qt, 1.94 Imp.qt)
Engine oil quantity without oil filter replacement:
2.0 L (2.11 US qt, 1.76 Imp.qt)
Engine oil total quantity:
4.3 L (4.55 US qt, 3.78 Imp.qt)
UF2P72E0.book Page 78 Tuesday, August 26, 2014 10:08 AM

Trouble recovery
79
EJU34562
Troubleshooting
If you have any trouble with your watercraft, use the troubleshooting chart to check for the
possible cause.
If you cannot find the cause, consult a Yamaha dealer.
EJU43590Troubleshooting chart
Confirm the possible cause and remedy, and then refer to the applicable page.
TROUBLE POSSIBLE CAUSE REMEDY PAGE
Engine does not
start (Starter motor
does not turn over)Engine shut-
off switchClip not in place Install clip
25
Fuse Burned out Replace fuse and
check wiring83
Battery Run down Recharge 70
Poor terminal con-
nectionsTighten as required
70
Terminal corroded Clean or replace 70
Starter motor Faulty Have serviced by
Yamaha dealer—
Engine does not
start (Starter motor
turns over)Throttle lever Squeezed Release 25
Fuel Empty Refill as soon as pos-
sible40
Stale or contaminat-
edHave serviced by
Yamaha dealer—
Fuel tank Water or dirt present Have serviced by
Yamaha dealer—
Spark plug Fouled or defective Have serviced by
Yamaha dealer—
Spark plug
capNot connected or
looseHave serviced by
Yamaha dealer—
Connected to wrong
cylinderHave serviced by
Yamaha dealer—
Fuel injec-
tion systemFuel pump faulty Have serviced by
Yamaha dealer—
UF2P72E0.book Page 79 Tuesday, August 26, 2014 10:08 AM

Trouble recovery
83
(2) Remove any weeds or debris from
around the jet intake, drive shaft, impel-
ler, jet pump housing, and jet thrust noz-
zle.
If debris is difficult to remove, consult a
Yamaha dealer.
EJU34642Jumping the battery
If the watercraft battery has run down, the en-
gine can be started using a 12-volt booster
battery and jumper cables.
EJU34664Connecting the jumper cables
WARNING
EWJ01251
To avoid battery explosion and serious
damage to the electrical system:
Do not reverse the polarity of the jumper
cables when connecting to the batter-
ies.
Do not connect the negative (–) jumper
cable to the negative (–) terminal of the
watercraft battery.
Do not touch the positive (+) jumper ca-
ble to the negative (–) jumper cable.
(1) Connect the positive (+) jumper cable to
the positive (+) battery terminals of both
batteries.
(2) Connect one end of the negative (–)
jumper cable to the negative (–) battery
terminal of the booster battery.(3) Connect the other end of the negative (–)
jumper cable to an engine hanger.
(4) Start the engine, and then disconnect the
jumper cables by reversing the steps
above. (See page 25 for information on
starting the engine.)
EJU34696Replacing the fuses
If a fuse is blown, replace it with the proper
fuse.
To replace a fuse:
(1) Remove the seat. (See page 34 for seat
removal and installation procedures.)
1Negative (–) jumper cable
2Booster battery
3Positive (+) jumper cable
4Engine hanger
1Good fuse
2Blown fuse
1
43
2
2 1
UF2P72E0.book Page 83 Tuesday, August 26, 2014 10:08 AM

Trouble recovery
84
(2) Loosen the cap on the electrical box and
remove it.
(3) Replace the blown fuse with the spare
fuse of the correct amperage by using
the fuse puller on the reverse side of the
cap. WARNING! Do not use fuses of a
different amperage than recommend-
ed. Substitution with a fuse that has
an improper rating can cause exten-sive electrical system damage and
possible fire.
[EWJ00803]
(4) Securely install the cap by tightening it
until it stops.
(5) Securely install the seat in its original po-
sition.
If the fuse immediately blows again, the elec-
trical system may be defective. If this occurs,
have a Yamaha dealer service the watercraft.
1Electrical box
2Cap
1
2
1Spare fuse
2Fuse
3Cap
1Fuse puller
Fuse amperage:
Battery fuse:
30 A
Main relay drive fuse:
10 A
Electronic throttle valve fuse:
10 A
Main fuse:
20 A
1
32
UF2P72E0.book Page 84 Tuesday, August 26, 2014 10:08 AM

86
Index
A
After removing the watercraft from the
water ..................................................... 68
B
Battery care.............................................. 70
Battery checks ......................................... 50
Battery, jumping ....................................... 83
Beaching and docking the watercraft ...... 67
Beverage holder ....................................... 38
Bilge water check..................................... 50
Bilge water, draining ................................ 43
Bilge water, draining on land ................... 43
Bilge water, draining on water ................. 44
Boarding alone ......................................... 62
Boarding and starting off from a dock ..... 66
Boarding the watercraft ........................... 62
Boarding with passenger(s) ..................... 63
Bow eye ................................................... 35
Bow storage compartment ...................... 36
Builder’s plate ............................................ 2
C
Capsized watercraft ................................. 66
Check engine warning ............................. 33
Cleaning ................................................... 73
Cleaning the watercraft ............................ 70
Cleat ......................................................... 36
Cooling water pilot outlet ......................... 27
Cooling water pilot outlet check .............. 55
Craft Identification Number (CIN)............... 1
Cruising limitations................................... 11
E
Emergency procedures ............................ 82
Engine break-in ........................................ 46
Engine compartment check ..................... 49
Engine idling speed check ....................... 55
Engine oil ................................................. 42
Engine oil and oil filter .............................. 77
Engine oil level check............................... 49
Engine oil requirements ........................... 42
Engine overheat warning ......................... 32
Engine serial number ................................. 1
Engine shut-off cord (lanyard) check ....... 52
Engine shut-off switch ............................. 25
Engine stop switch................................... 25
Engine unit check..................................... 49Enjoy your watercraft responsibly ............ 19
Equipment ................................................ 34
F
Fire extinguisher check ............................ 53
Fire extinguisher holder and cover........... 38
Fire extinguisher holder, cover, and
band checks ......................................... 53
Flushing the cooling water passages....... 69
Fuel .......................................................... 40
Fuel level check........................................ 49
Fuel level meter ........................................ 31
Fuel level warning..................................... 31
Fuel requirements .................................... 40
Fuel system checks ................................. 49
Fuses, replacing ....................................... 83
G
Getting to know your watercraft .............. 56
Glossary, watercraft ................................. 20
Glove compartment ................................. 37
H
Handgrip .................................................. 34
Hazard information................................... 15
Hood check .............................................. 54
Hour meter/voltmeter ............................... 30
Hull and deck check ................................ 54
I
Identification numbers ............................... 1
Information display................................... 29
J
Jet intake and impeller, cleaning.............. 82
Jet intake checks ..................................... 54
Jumper cables, connecting ...................... 83
L
Labels, important ....................................... 4
Labels, other .............................................. 8
Labels, warning .......................................... 5
Launching the watercraft ......................... 57
Learning to operate your watercraft......... 56
Leaving the watercraft.............................. 58
Limitations on who may operate the
watercraft .............................................. 10
Long-term storage ................................... 73
Lubrication ............................................... 73
M
Main components, location of ................. 21
UF2P72E0.book Page 86 Tuesday, August 26, 2014 10:08 AM