fuses YAMAHA VITY 125 2008 Owners Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
6-25
6
EAUT2022
Replacing the fuse The fuse holder is located beside the
battery. Remove panel B to access the
fuse. (See page 6-6.)
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to “OFF” and turn off
all electrical circuits.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage.
CAUTION:
ECAT1061


Do not use a fuse of a higher
amperage rating than recom-
mended to avoid causing exten-
sive damage to the electrical
system and possibly a fire.


After removing and installing
the main fuse, be sure to turn
the main switch from “ON” to
“OFF” three times in 3 seconds
intervals to initialize the idlespeed control system.
3. Turn the key to “ON” and turn on
the electrical circuits to check if the
devices operate.
4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
EAU45501
Replacing the headlight bulb This model is equipped with a quartz
bulb headlight. If the headlight bulb
burns out, replace it as follows.
1. Place the vehicle on the center-
stand.
2. Remove cowling B. (See page
6-6.)
3. Remove the headlight bulb cover.
4. Remove the headlight bulb holder
by turning it counterclockwise, and
then remove the defective bulb
from the headlight unit.
1. Fuse
2. Spare fuseSpecified fuse:
15.0 A1
2
1. Headlight bulb cover
1
U4P7E1E0.book Page 25 Wednesday, December 12, 2007 9:37 AM

SPECIFICATIONS
8-3
8
Fuses:Main fuse:
15.0 A
U4P7E1E0.book Page 3 Wednesday, December 12, 2007 9:37 AM