start stop button YAMAHA VX DELUXE 2020 Bruksanvisningar (in Swedish)

–8–
Exercise 2: Starting and stopping engine
Drill 1: Starting the engine
1. VX Deluxe / VX Cruiser / VX Limited: Press the unlock button 1 on the remote control
transmitter to deactivate the security system. (See the “Yamaha Security System” sec-
tion in the owner’s/operator’s manual for more information.)
VX-C / VX: Skip to step 2. (Your watercraft is not equipped with Yamaha Security Sys-
tem.)
2. Attach the engine shut-off cord 2 to your wrist. Insert the clip 3, under the engine
shut-off switch 4. Make sure to keep the engine shut-off cord free from the handlebars
so the engine stops if the operator falls off. The clip may not pull free if the cord is
wrapped around the handlebars.
34
2
3
4
2
VX-C VX / VX Deluxe / VX Cruiser / VX Limited
F4G-72-forPrint.book Page 8 Tuesday, July 2, 2019 11:49 AM

–9–
Exercise 2: Starting and stopping engine
3. Push the start switch 5 (green button).
VX-C:
Do not squeeze the throttle lever. Otherwise, the engine will not start.
The engine is connected directly to the drive unit, so be prepared for forward thrust
when the engine starts. Apply only enough throttle to keep the engine running.
VX / VX Deluxe / VX Cruiser / VX Limited:
Do not squeeze either the throttle lever or RiDE lever. Otherwise, the engine will not
start.
4. Release the start switch as soon as the engine starts to run.
55
VX-C VX / VX Deluxe / VX Cruiser / VX Limited
F4G-72-forPrint.book Page 9 Tuesday, July 2, 2019 11:49 AM

–10–
Exercise 2: Starting and stopping engine
Drill 2: Stopping the engine
1. Release the throttle lever and let the engine slow to idle.
2. Push the engine stop switch 1 (red button). The ignition circuit opens and stops the
engine immediately.
3. Practice pulling the engine shut-off cord to remove the clip from the engine shut-off switch.
Tips:
1. Attach the engine shut-off cord to your left wrist before starting the engine. To prevent
accidental starting, always remove the clip from the engine shut-off switch when the
engine is not running.
2. Do not operate the start switch for more than 5 seconds at a time. Never push the start
switch while the engine is running.
3. If the engine does not start in 5 seconds, release the start switch and try again after
15 seconds. Continuous cranking for more than 5 seconds will discharge the battery
and the engine will not start.
4. When the engine starts, thrust from the jet unit will move the watercraft. Squeezing the
throttle lever produces more thrust. Apply only enough throttle to keep the engine run-
ning.
1
STOP
1
VX-C VX / VX Deluxe / VX Cruiser / VX Limited
VX-C VX / VX Deluxe / VX Cruiser / VX Limited
STOP
F4G-72-forPrint.book Page 10 Tuesday, July 2, 2019 11:49 AM