warning light YAMAHA VX110 2005 Service Manual
[x] Cancel search | Manufacturer: YAMAHA, Model Year: 2005, Model line: VX110, Model: YAMAHA VX110 2005Pages: 347, PDF Size: 14.17 MB
Page 150 of 347

5-51
EPOWRCAMSHAFTS
Install the exhaust and intake camshaft
caps.
NOTE:
Gradually tighten the intake and exhaust
camshaft cap bolts in 2–3 steps in the
sequence shown.
T R..
Camshaft cap bolt:
10 N m (1.0 kgf m, 7.2 ft lb)
NOTE:
Make sure that the punch marks c
on the
camshafts are aligned with the arrow marks
d
on the camshaft caps.
Out of alignment →
Reinstall.
Remove the wire from the timing chain.
10 1 4 5 8
17 5 1 4 8 15 9 12 149 3 2
7 6
18 7 3 2 6
13 11 10 16
3. Install:
Timing chain tensioner
Installation steps:
While lightly pressing the timing chain
tensioner rod by hand, turn the tensioner
rod fully clockwise with a thin screwdriver
1
.
NOTE:
Make sure that the tensioner rod has been
fully set clockwise.
With the timing chain tensioner rod
turned all the way into the timing chain
tensioner housing (with the thin screw-
driver still installed), install the gasket and
the timing chain tensioner 2
onto the cyl-
inder block.
WARNING
Always use a new gasket.
Tighten the timing chain tensioner bolts
3
to the specified torque.
NOTE:
The “UP” mark on the timing chain ten-
sioner should face up.
33
2
ProCarManuals.com
Page 283 of 347

7-56
E
–+ELECINDICATION SYSTEM
Overheat warning indicator
1. Check:
Overheat warning indicator
Does not come on → Replace the multi-
function meter.
Checking steps:
Start the engine.
Disconnect the thermoswitch (engine)
connector 1 (blue), engine temperature
sensor connector 2 (black), or ther-
moswitch (exhaust) 3 connector.
Connect the jumper lead to the female
terminal of the disconnected connector.
Check that the multifunction meter over-
heat warning indicator blinks, then comes
on. The buzzer also begins to sound
intermittently, then sounds continuously.
3
12
Check engine warning indicator
1. Check:
Check engine warning indicator
Does not come on → Replace the multi-
function meter.
Checking steps:
Start the engine.
Disconnect the coupler of a sensor (e.g.,
engine temperature sensor) that normally
activates the check engine warning indi-
cator when a malfunction occurs.
Check that the warning light and check
engine warning indicator begin to blink
and the buzzer sounds intermittently.
ProCarManuals.com
Page 340 of 347

9-7
E
TRBL
ANLS
TROUBLE ANALYSIS
Starting system
Start switch 7
Starter relay 7
Starter motor 7
Charging system
Lighting coil 7
Rectifier/regulator 7
Fuses 7
Battery leads—
Battery 3
Remote control system (Deluxe model only)
Remote control unit 7
HULL AND HOOD
Steering column 8
Water lock 8
Exhaust hose 8
Muffler 8
Drain plugs 8 Trouble mode Check elements
ENGINE WILL NOT START
HARD STARTING
ROUGH IDLING
HIGH IDLING
ENGINE STALLS
POOR ACCELERATION
ENGINE WILL NOT STOP
POOR PERFORMANCE
LIMITED ENGINE SPEED
OVERHEATING
LOW OIL PRESSURE
LOOSE STEERING
BILGE INCREASE
IRREGULAR WARNING INDICATION
POOR BATTERY CHARGING
Relative partReference
chapter
ProCarManuals.com