low beam YAMAHA WARRIOR 350 2001 Manuale de Empleo (in Spanish)

Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B067_YFM350X-60:YFM350TOC-E.frame
EL
Drive chain cleaning and
lubrication....................................... 8-61
Cable inspection and lubrication .... 8-63
Brake and shift pedal/brake and
clutch lever lubrication .................. 8-63
Upper and lower arm pivot
lubrication....................................... 8-65
Rear arm pivot lubrication............... 8-67
Wheel removal ................................. 8-69
Wheel installation ............................ 8-71
Battery ............................................... 8-73
Replenishing the battery fluid ......... 8-77
Fuse replacement ............................. 8-81
Replacing the headlight bulb .......... 8-83
Headlight beam adjustment ............ 8-89
Troubleshooting ............................... 8-91
Troubleshooting chart ..................... 8-93
CLEANING AND STORAGE................... 9-1
A. Cleaning ......................................... 9-1
B. Storage ........................................... 9-7SPECIFICATIONS ..................................10-1
HOW TO USE THE CONVERSION
TABLE ....................................................11-1
9
1011

4-7
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B067_YFM350X-60:YFM350-4.frame
EL
EBU00734
Light switch “LIGHTS”
Turn the switch to the “LO” position to switch
on the low beam and the taillight.
Turn the switch to the “HI” position to switch
on the high beam and the taillight.
Turn the switch to the “OFF” position to switch
off the headlight and the taillight.
CAUTION:

Do not use the headlight with the engine
turned off for more than thirty minutes. The
battery may discharge to the point that the
starter motor will not operate properly. If this
should happen, remove the battery and re-
charge it.

8-89
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B067_YFM350X-60:YFM350-8.frame
EL
7. Put a new bulb into position and secure it
in place with the bulb holder.
8. Install the bulb holder cover.CAUTION:Make sure the bulb holder cover is securely fit-
ted over the bulb holder and seated againstthe reflector.
9. Install the headlight assembly and the
guard.
Adjust the headlight beam if necessary.
EBU00409
Headlight beam adjustmentCAUTION:It is advisable to have a Yamaha dealer makethis adjustment.
1. Vertical adjustment:
To raise the beam, turn the adjusting
screw clockwise.
To lower the beam, turn the screw coun-
terclockwise.
1. Vertical adjusting screw (´ 2)
1. Vis de réglage vertical (´ 2)
1. Tornillo de ajuste vertical (´ 2)1. Bulb holder cover 2. Bulb holder
3. Reflector
1. Cache de la fixation d’ampoule 2. Fixation d’ampoule
3. Réflecteur
1. Cubierta del portabombillas 2. Portabombillas
3. Reflector