warning YAMAHA WARRIOR 350 2001 User Guide

4-19
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B067_YFM350X-60:YFM350-4.frame
EL
WARNING

l
Always set the parking brake before start-
ing the engine. The ATV could start mov-
ing unexpectedly if the parking brake is
not applied. This could cause loss of con-
trol or a collision.
l
Always be sure you have released the
parking brake before you begin to ride.
The brake could overheat if you ride the
ATV without releasing the parking brake.
You could lose braking performance
which could cause an accident. You could
also wear out the brakes prematurely.

4-29
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B067_YFM350X-60:YFM350-4.frame
EL
EBU00633
Front shock absorber adjustment
The spring preload can be adjusted to suit the
rider’s weight and riding conditions.
Adjust the spring preload as follows:
To increase the spring preload, turn the adjust-
er in direction a.
To decrease the spring preload, turn the ad-
juster in direction b.
WARNING
Always adjust the shock absorbers on the left
and right side to the same setting. Uneven ad-
justment can cause poor handling and loss ofstability, which could lead to an accident.Standard position: A
A
- Minimum (Soft)
E - Maximum (Hard)
a. Increase spring preload
b. Decrease spring preload
a. Augmente la précontrainte du ressort.
b. Diminue la précontrainte du ressort.
a. Aumentar la precarga del muelle
b. Reducir la precarga del muelle

4-31
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B067_YFM350X-60:YFM350-4.frame
EL
EBU00743
Rear shock absorber adjustment
The spring preload and damping force of the
rear shock absorber can be adjusted to suit the
rider’s weight and riding conditions.
WARNING
This shock absorber contains highly pressurized
nitrogen gas. Read and understand the following
information before handling the shock absorber.
1. Do not tamper with or attempt to open
the cylinder assembly.
2. Do not subject the shock absorber to an
open flame or other high heat source.
This may cause the unit to explode due to
excessive gas pressure.
3. Do not deform or damage the cylinder in
any way. Cylinder damage will result in
poor damping performance.
4. Take the shock absorber to a Yamaha
dealer for any service.
1. Adjust spring preload as follows.
a. Loosen the locknut.
b. Turn the adjusting ring in direction a to
increase the spring preload and in direc-
tion b to decrease the spring preload.
1. Adjusting ring 2. Locknut
a. Increase spring preload
b. Decrease spring preload
1. Bague de réglage 2. Contre-écrou
a. Augmente la précontrainte du ressort.
b. Diminue la précontrainte du ressort.
1. Anillo de ajuste 2. Contratuerca
a. Aumenta la precarga del muelle
b. Disminuya la precarga del muelle

5-4
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B067_YFM350X-60:YFM350-5.frame
ERWARNING
Always inspect your ATV each time you use it to make sure the ATV is in safe operating condition.
Always follow the inspection and maintenance procedures and schedules described in the Owner’s
Manual. Failure to inspect increases the possibility of an accident or equipment damage.
AVERTISSEMENT

Toujours effectuer ces contrôles avant chaque départ afin de s’assurer que le VTT peut être utilisé en toute sécurité.
Toujours respecter les procédés et intervalles de contrôle et d’entretien repris dans ce manuel. Omettre ces con-
trôles accroît les risques d’accident ou d’endommagement du véhicule.
ADVERTENCIA

Inspeccionar siempre el ATV cada vez que vaya a utilizarse, para asegurarse de que está en condiciones
de funcionar sin peligro.
Seguir siempre los procedimientos y programas de inspección y mantenimiento descritos en el
Manual del Usuario. Si no se inspecciona la máquina, aumenta el riesgo de accidente o avería.

5-7
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B067_YFM350X-60:YFM350-5.frame
EL
3. Brake fluid leakage
Check to see if any brake fluid is leaking
out of the pipe joints or master cylinders.
Apply the brakes firmly for one minute. If
there is any leaking, have the machine in-
spected by a Yamaha dealer.
4. Brake operation
Test the brakes at slow speed after start-
ing out to make sure they are working
properly. If the brakes do not provide
proper braking performance, inspect the
brake pads for wear. (See page 8-39.)
WARNING

Always check the brakes at the start of every
ride. Do not ride the ATV if you find any prob-
lem with the brakes or you could lose braking
ability, which could lead to an accident. If a
problem cannot be corrected by the adjust-
ment procedures provided in this manual,
have the ATV inspected by a Yamaha dealer.

5-11
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B067_YFM350X-60:YFM350-5.frame
EL
1. Filler tube 2. Fuel level
1. Tube de remplissage 2. Niveau de carburant
1. Tubo de llenado 2. Nivel de combustible
WARNING

l
Do not overfill the fuel tank. Fuel expands
when it heats up. If the fuel tank is over-
filled, fuel could spill out due to heat from
the engine or the sun.
l
Be careful not to spill fuel, especially on
the engine or exhaust pipe which can
cause a fire and severe injury. Wipe up
any spilled fuel immediately.
l
Do not refuel right after the engine has
been running and is still very hot.
l
Be sure the fuel tank cap is closed secure-
ly.

5-19
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B067_YFM350X-60:YFM350-5.frame
EL
EBU00499
Battery
Check fluid level and fill if necessary. Use only
distilled water if refilling is necessary. (See
pages 8-73 ~ 8-79.)
EBU00158
Tires
Always use the recommended tires.
WARNING
Use of improper tires on this ATV, or opera-
tion of this ATV with improper or uneven tire
pressure, may cause loss of control, increasing
your risk of accident.
Pay attention to the following.
1. The tires listed below have been ap-
proved by Yamaha Motor Co., Ltd. for this
model. Other tire combinations are not
recommended.
Manufacturer Size Type
Front DUNLOP AT22 ´ 7-10 KT701
Rear DUNLOP AT22 ´ 10-9 KT775B

6-1
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B067_YFM350X-60:YFM350-6.frame
EL
EBU00162
OPERATION
Read the Owner’s Manual carefully before
riding the ATV.
WARNING

Read the Owner’s Manual carefully to become
familiar with all controls. Loss of control could
cause an accident or injury. If there is a control
or function you do not understand, ask your
Yamaha dealer.

6-3
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B067_YFM350X-60:YFM350-6.frame
EL
EBU00514
Starting a cold engine
WARNING

Always make sure all control cables work
smoothly before you begin riding in cold
weather. If the control cables are frozen or do
not work smoothly, you could be unable to
control the ATV, which could lead to an acci-
dent or collision.
1. Set the parking brake.
2. Turn the fuel cock to “ON”.
3. Turn the main switch to “ON” and the en-
gine stop switch to “RUN”.
4. Shift the transmission into neutral.

6-13
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B067_YFM350X-60:YFM350-6.frame
EL
5. Check behind you for people or obstacles,
then release the rear brake pedal.
6. Open the throttle lever gradually and re-
lease the clutch lever slowly. Continue to
watch to the rear while backing.
WARNING

Improper operation in reverse could make you
hit an obstacle or person behind you, resulting
in serious injury. When you shift into reverse,
make sure there are no obstacles or people be-
hind you. When it is safe to proceed, go slowly.