engine YAMAHA WARRIOR 350 2003 User Guide

4-17 1. Button 2. Lock plate
1. Bouton 2. Verrou
1. Botón 2. Placa de bloqueo
1. Locked position
1. Position verrou bloqué
1. Posición bloqueada
EBU00081
Parking brake
Use the parking brake when you have to start the
engine or park the machine, especially on a slope.
Squeeze the clutch lever while pushing the button,
then push in the lock plate to apply the parking
brake. Squeeze the clutch lever to release the
parking brake.NOTE:When the parking brake is used, engine speed is
limited to 2,300 r/min. Be sure the parking brake is
released before moving the throttle lever. Other-
wise, the engine will misfire, preventing normal op-
eration.
U5NF61.book Page 17 Wednesday, June 13, 2001 5:18 PM

4-19
WARNING


Always set the parking brake before start-
ing the engine. The ATV could start mov-
ing unexpectedly if the parking brake is not
applied. This could cause loss of control or
a collision.


Always be sure you have released the
parking brake before you begin to ride. The
brake could overheat if you ride the ATV
without releasing the parking brake. You
could lose braking performance which
could cause an accident. You could also
wear out the brakes prematurely.
U5NF61.book Page 19 Wednesday, June 13, 2001 5:18 PM

4-21 1. Shift pedal
1. Pédale de sélection
1. Pedal del cambio
1. Drive select lever
1. Levier de présélection
1. Palanca de selección de gama
EBU00082
Shift pedal
This machine is equipped with a constant-mesh 6-
speed transmission. The shift pedal is located on
the left side of the engine and is used in combina-
tion with the clutch when shifting.
EBU00085
Drive select lever
The drive select lever is used for driving the machine
either forward or in reverse. Refer to page 6-11 for
drive select lever operation.
U5NF61.book Page 21 Wednesday, June 13, 2001 5:18 PM

4-23 1. Fuel tank cap
1. Bouchon de réservoir de carburant
1. Tapón del depósito de combustible
EBU00092
Fuel tank cap
Remove the fuel tank cap by turning it counter-
clockwise.
EBU00093
Fuel cock
The fuel cock supplies fuel from the fuel tank to the
carburetor.
The fuel cock has three positions.
OFF: With the lever in this position, fuel will not
flow. Always turn the lever to this position
when the engine is not running.
ON: With the lever in this position, fuel flows to
the carburetor. Normal riding is done with
the lever in this position.
RES: This indicates reserve. If you run out of fuel
while riding, turn the lever to this position.
THEN FILL THE FUEL TANK AT THE
FIRST OPPORTUNITY. After refuelling, re-
turn the fuel cock lever to the “ON” position.
U5NF61.book Page 23 Wednesday, June 13, 2001 5:18 PM

4-25 A. Starter (choke) 1. Fully open
2. Half open 3. Closed
A. Starter (enrichisseur) 1. Complètement ouvert
2. Mi-ouvert 3. Fermé
A. Starter (choke) 1. Abre completamente
2. Semiabierto 3. Cerrado
EBU00094
Starter (choke)
Starting a cold engine requires a richer air-fuel
mixture.
A separate starter circuit supplies this mixture.
Move in direction
a to turn on the starter (choke).
Move in direction
b to turn off the starter (choke).
Refer to “Starting a cold engine” for proper opera-
tion. (See page 6-3.)
U5NF61.book Page 25 Wednesday, June 13, 2001 5:18 PM

5-1
EBU00113
PRE-OPERATION CHECKS
Before using this machine, check the following points:
ITEM ROUTINE PAGE
BrakeCheck operation, fluid level and fluid leakage.
Fill with DOT 4 brake fluid if necessary.5-5 ~ 5-7,
8-39 ~ 8-49
ClutchCheck operation, condition and lever free play. 8-57
Parking brakeCheck operation, condition and cable free play. 8-51 ~ 8-53
FuelCheck fuel level.
Fill with fuel if necessary.5-9 ~ 5-11
Engine oilCheck oil level.
Fill with oil if necessary.5-13 ~ 5-15,
8-15 ~ 8-23
Drive chainCheck chain slack and condition.
Adjust if necessary.5-15, 8-59 ~ 8-63
ThrottleCheck for proper throttle cable operation and free play. 5-17, 8-37
Wheels and tiresCheck tire pressure, wear and damage.5-19 ~ 5-25,
8-71 ~ 8-73
Fittings and FastenersCheck all fittings and fasteners. 5-17
LightsCheck for proper operation. 5-17, 8-85 ~ 8-95
BatteryCheck fluid level.
Fill with distilled water if necessary.5-19, 8-75 ~ 8-81
U5NF61.book Page 1 Wednesday, June 13, 2001 5:18 PM

5-11 1. Fuel tank filler tube
2. Fuel level
1. Tube de remplissage du réservoir de carburant
2. Niveau de carburant
1. Tubo de relleno del depósito de combustible
2. Nivel de combustible
WARNING
_

Do not overfill the fuel tank. Fuel expands
when it heats up. If the fuel tank is over-
filled, fuel could spill out due to heat from
the engine or the sun.


Be careful not to spill fuel, especially on
the engine or exhaust pipe which can
cause a fire and severe injury. Wipe up any
spilled fuel immediately.


Do not refuel right after the engine has
been running and is still very hot.


Be sure the fuel tank cap is closed secure-
ly.
_
U5NF61.book Page 11 Wednesday, June 13, 2001 5:18 PM

5-13
EBU00947
Engine oil
Make sure the engine oil is at the specified level.
Fill with oil as necessary. (See pages 8-15 ~ 8-23
for details.)
Recommended oil:
Recommended engine oil classification:
API Service SE, SF, SG type or higher
-20˚ -10˚ 0˚
10˚20˚ 30˚40˚50˚C
10W/30
15W/4020W/4020W/50
10W/40
5W/30
U5NF61.book Page 13 Wednesday, June 13, 2001 5:18 PM

5-15
CAUTION:_ Be sure to use motor oils that do not contain
anti-friction modifiers. Passenger car motor
oils (often labeled “ENERGY CONSERVING II”)
contain anti-friction additives which will cause
clutch and/or starter clutch slippage, resulting
in reduced component life and poor engine
performance.
EBU00498
Chain
Check the general condition of the chain and check
the chain slack before every ride. Lubricate and ad-
just the chain as necessary. (See pages 8-59 ~ 8-63
for details.)Oil quantity:
Total amount:
3.2 L
Periodic oil change:
2.4 L
With oil filter replacement:
2.5 L
U5NF61.book Page 15 Wednesday, June 13, 2001 5:18 PM

5-17
EBU00151
Throttle lever
Check to see that the throttle lever operates cor-
rectly. It must open smoothly and spring back to
idle position when released. Repair as necessary
for proper operation.
EBU00152
Fittings and Fasteners
Always check the tightness of chassis fittings and
fasteners before a ride. Take the machine to a
Yamaha dealer or refer to the Service Manual for
correct tightening torque.
EBU00803*
Lights
Check the headlights and tail/brake light to make
sure they are in working condition. Repair as nec-
essary for proper operation.
EBU00912
Switches
Check the operation of the light switch, engine
stop switch and any other switches. Repair as nec-
essary for proper operation.
U5NF61.book Page 17 Wednesday, June 13, 2001 5:18 PM