oil dipstick YAMAHA WARRIOR 350 2003 Owners Manual
[x] Cancel search | Manufacturer: YAMAHA, Model Year: 2003, Model line: WARRIOR 350, Model: YAMAHA WARRIOR 350 2003Pages: 378, PDF Size: 14.1 MB
Page 258 of 378
8-15 1. Dipstick 2. Maximum level mark
3. Minimum level mark
1. Jauge 2. Repère de niveau maximum
3. Repère de niveau minimum
1. Varilla 2. Marca de nivel máximo
3. Marca de nivel mínimo
EBU00949*
Engine oil
Engine oil level measurement
1. Place the machine on a level surface.
2. Warm up the engine for several minutes, and
then stop it.
3. Remove the dipstick, and then wipe it off with
a clean rag. Insert the dipstick in the filler hole
without screwing it in.NOTE:_ Wait a few minutes until the oil level settles before
checking. _4. Remove the dipstick, and then check the oil
level.
5. The oil level should be between the maxi-
mum and minimum marks. If the level is low,
add oil to raise it to the proper level.CAUTION:_ Be sure no foreign material enters the crank-
case. _
U5NF61.book Page 15 Wednesday, June 13, 2001 5:18 PM
Page 260 of 378
8-17 1. Drain bolt 2. O-ring
3. Compression spring 4. Oil strainer
1. Boulon de vidange 2. Joint torique
3. Ressort de compression 4. Crépine à huile
1. Perno de drenaje 2. Junta tórica
3. Muelle de compresión 4. Tamiz de aceite
Engine oil replacement and oil filter element
cleaning
1. Place the machine on a level surface.
2. Warm up the engine for several minutes and
stop it.
3. Place a container under the engine.
4. Remove the dipstick, and then remove the
drain bolt to drain the oil.CAUTION:_ When removing the drain bolt, the compres-
sion spring, oil strainer and O-ring will fall out.
Take care not to lose these parts. _
U5NF61.book Page 17 Wednesday, June 13, 2001 5:18 PM
Page 262 of 378
8-19 1. Oil filter cover 2. Bolt (× 3)
3. Oil filter 4. O-ring
1. Couvercle du filtre à huile 2. Boulon (× 3)
3. Filtre à huile 4. Joint torique
1. Tapa del filtro de aceite 2. Perno (× 3)
3. Filtro de aceite 4. Junta tórica
5. Remove the oil filter cover by removing the
bolts and then remove the oil filter element.
6. Clean the oil strainer and oil filter element
with solvent.
7. Check the O-ring for damage and replace it if
damaged.
8. Install the oil filter element, and O-ring.
9. Install the oil filter cover by installing the bolts.
10. Install the oil strainer, compression spring
and drain bolt. Tighten the drain bolt and oil
filter cover bolts to the specified torques.CAUTION:_ Before installing the drain bolt, be sure to in-
stall the O-ring, compression spring and oil
strainer. _11. Fill the engine with oil, and then install the
dipstick. Tightening torques:
Drain bolt (engine):
32 Nm (3.2 m·kgf)
Filter cover bolt:
10 Nm (1.0 m·kgf)
U5NF61.book Page 19 Wednesday, June 13, 2001 5:18 PM