oil dipstick YAMAHA WARRIOR 350 2004 Manuale de Empleo (in Spanish)

8-15 1. Dipstick 2. Maximum level mark
3. Minimum level mark
1. Jauge 2. Repère de niveau maximum
3. Repère de niveau minimum
1. Varilla 2. Marca de nivel máximo
3. Marca de nivel mínimo
EBU01181
Engine oil
Engine oil level measurement
1. Place the ATV on a level surface.
2. Warm up the engine for several minutes, and
then stop it.
3. Remove the engine oil filler cap, and then
wipe the dipstick off with a clean rag. Insert
the dipstick in the filler hole without screwing
it in.NOTE:_ Wait a few minutes until the oil level settles before
checking. _4. Remove the dipstick, and then check the oil
level.NOTE:_ The oil level should be between the maximum and
minimum level marks. _
U5NF63.book Page 15 Wednesday, March 12, 2003 10:06 AM

8-17 1. Engine oil drain bolt 2. O-ring
3. Compression spring 4. Engine oil strainer
1. Boulon de vidange de l’huile moteur
2. Joint torique
3. Ressort de compression
4. Crépine à huile de moteur
1. Perno de drenaje del aceite de motor
2. Junta tórica
3. Muelle de compresión
4. Tamiz de aceite de motor
5. If the engine oil is below the minimum level
mark, add sufficient oil of the recommended
type to raise it to the correct level.CAUTION:_ Be sure no foreign material enters the crank-
case. _6. Insert the dipstick into the oil filler hole, and
then tighten the engine oil filler cap.
Engine oil replacement and oil filter element
cleaning
1. Place the ATV on a level surface.
2. Warm up the engine for several minutes and
stop it.
3. Place a container under the engine to collect
the used oil.
4. Remove the engine oil filler cap, and then re-
move the drain bolt to drain the oil.CAUTION:_ When removing the drain bolt, the compres-
sion spring, oil strainer and O-ring will fall out.
Take care not to lose these parts. _
U5NF63.book Page 17 Wednesday, March 12, 2003 10:06 AM