battery YAMAHA WR 250F 2004 Owner's Manual

6 - 45
–+ELECCHARGING SYSTEM
EC680000
CHARGING SYSTEM
EC681001INSPECTION STEPS
If the battery is not charged, use the following inspection steps.
*1 marked: Refer to “FUSE INSPECTION” section in the CHAPTER 3.
*2 marked: Refer to “BATTERY INSPECTION AND CHARGING” section in the CHAPTER 3.
NOTE:Remove the following parts before inspection.
1) Seat
2) Fuel tank
Use the following special tool in this inspection.
*1 Check fuse.Replace fuse and check
wire harness.
*2 Check battery. Recharge or replace.
Check each coupler and wire
connection.Repair or replace.
Check charging voltage. Charging system is good.
Check AC magneto. Charging coil Replace.
Replace rectifier/regulator.
Pocket tester:
YU-3112-C/
90890-03112
No good
OK
No good
OK
No good
OK
OK
No good
No good
OK

6 - 73
–+ELECLIGHTING SYSTEM
AC MAGNETO INSPECTION
1. Inspect:
Lighting coil resistance
Out of specification
→
Replace.
Tester (+) lead →
Yellow lead 1

Tester (–) lead →
Ground 2

Lighting coil
resistanceTester
selector
position
0.224 ~ 0.336 Ω

at 20 °C (68 °F)Ω
×
1
RECTIFIER/REGULATOR
INSPECTION
1. Connect the battery leads.
2. Start the engine.
3. Turn on the headlight and tail-
light by turning on the light
switch.
4. Inspect:
Out-put voltage
Out of specification
→
Replace rectifier/regulator.
Tester (+) lead →
Yellow lead 1

Tester (–) lead →
Black lead 2

Out-put
voltageTester
selector
position
13.0 ~ 14.0 V
at 5,000 r/minACV-20
R
BW
Y1
2
VERIFICATION DE LA MAGNETO
CA
1. Contrôler:
Résistance de la bobine d’éclai-
rage
Ne correspond pas aux spécifica-
tions → Remplacer.
Fil (+) de multimètre → Fil jaune 1
Fil (–) de multimètre → Masse 2
Résistance
bobine
d’éclairagePosition de
sélecteur du
multimètre
0,224 à 0,336 Ω
à 20 °C (68 °F)Ω × 1
INSPECTION DU REGULATEUR
DE TENSION
1. Brancher les câbles de batterie.
2. Démarrer le moteur.
3. Allumer le phare et le feu arrière en
actionnant l’interrupteur lumières.
4. Contrôler:
Tension de sortie
Hors spécification → Remplacer
le régulateur de tension.
Fil (+) de multimètre → Fil bleu 1
Fil (–) de multimètre → Fil noir 2
Tension de
sortiePosition de
sélecteur du
multimètre
13,0 à 14,0 à
5.000 tr/mnACV-20
SYSTEME D’ECLAIRAGE