transmission oil YAMAHA XJ600S 2000 Owners Manual

L
3-3
INSTRUMENT AND CONTROL FUNCTIONS
/Net/layout8/layout_G2/work/Imai_work/OM-PS/AA9156_XJ600SN-E6/English/E-3.frame
1. Steering lock
EAU02934
Steering lock (for XJ600N)
To lock the steering
Turn the handlebars all the way to the
right and open the steering lock cover.
Insert the key and turn it 1/8 turn coun-
terclockwise. Then, push the key in while
turning the handlebars slightly to the left
and turn the key 1/8 turn clockwise.
Check that the steering is locked, re-
move the key and close the lock cover.
To unlock the steering
Insert the key, push it in and turn it 1/8
turn counterclockwise so that it moves
out. Then, release and remove the key.
000 001
0000
3
45
21XJ600S
1. Left turn indicator light Ò Ó
2. High beam indicator light Ò Ó
3. Right turn indicator light Ò Ó
4. Neutral indicator light Ò Ó
5. Oil level indicator light Ò Ó
EAU00056
Indicator lights
EAU00058
Turn indicator lights Ò Ó / Ò Ó
The corresponding indicator flashes
when the turn switch is moved to the
left or right.
EAU00061
Neutral indicator light Ò Ó
This indicator comes on when the
transmission is in neutral.
1. Neutral indicator light Ò Ó
2. Left turn indicator light Ò Ó
3. Right turn indicator light Ò Ó
4. High beam indicator light Ò Ó
5. Oil level indicator light Ò Ó
EAU00063
High beam indicator light Ò Ó
This indicator comes on when the
headlight high beam is used.
EAU01313
Oil level indicator light Ò Ó
This indicator comes on when the oil
level is low. This light circuit can be
checked by the procedure on page 3-5.

L
3-5
INSTRUMENT AND CONTROL FUNCTIONS
/Net/layout8/layout_G2/work/Imai_work/OM-PS/AA9156_XJ600SN-E6/English/E-3.frame
EAU00071
Oil level indicator circuit check
Turn the main switch to ÒONÓ and
the engine stop switch to Ò Ó.
Oil level indicator light
does not come on.Oil level indicator light
comes on.
Check engine oil level.
Oil level indicator light
comes on.Oil level indicator light
does not come on.
Engine oil level and
electrical circuit are OK.
Go ahead with riding.
Put the transmission in neutral
or apply the clutch lever, then
push the start switch.
Oil level
is OK.
Supply
engine oil.
Oil level
is low.
Ask a Yamaha dealer to
inspect electrical circuit.

L
5-3
OPERATION AND IMPORTANT RIDING POINTS
/Net/layout8/layout_G2/work/Imai_work/OM-PS/AA9156_XJ600SN-E6/English/E-5.frame
1. Turn the fuel cock to ÒONÓ.
2. Turn the main switch to ÒONÓ and
the engine stop switch to Ò Ó.
3. Shift transmission into neutral.
NOTE:
When the transmission is in neutral, the
neutral indicator light should be on. If
the light does not come on, ask a
Yamaha dealer to inspect it.
4. Turn on the starter (choke) and
completely close the throttle grip.
5. Start the engine by pushing the
start switch.
NOTE:
If the engine fails to start, release the
start switch, wait a few seconds, then
try again. Each attempt should be as
short as possible to preserve the bat-
tery. Do not crank the engine more
than 10 seconds on any one attempt.
EC000034
CAUTION:
The oil level indicator light should
come on when the start switch is
pushed and should go off when the
start switch is released. If the indica-
tor light flickers or remains on, im-
mediately stop the engine and
check the engine oil level and for oil
leakage. If necessary, fill the engine
with oil and check to see that the oil
level indicator light goes off. If the
light does not go off even with suffi-
cient oil in the crankcase or the light
does not come on when pushing the
start switch, consult a Yamaha
dealer.
6. After starting the engine, move the
starter (choke) halfway back.
NOTE:
For maximum engine life, never accel-
erate hard with a cold engine!7. After the engine is warm, turn off
the starter (choke) completely.
NOTE:
The engine is warm when it responds
normally to the throttle with the starter
(choke) turned off.