warning YAMAHA XMAX 250 2007 Owner's Manual

YAMAHA XMAX 250 2007 Owner's Manual XMAX 250 2007 YAMAHA YAMAHA https://www.carmanualsonline.info/img/51/52929/w960_52929-0.png YAMAHA XMAX 250 2007 Owner's Manual

Page 43 of 84

YAMAHA XMAX 250 2007 Owners Manual NOTE:
If you do not have the tools or expe-
rience required for a particular job,
have a Yamaha dealer perform it for
you.
EWA10350
s s
WARNING
Modifications not approved by
Yamaha may cause loss of p

Page 52 of 84

YAMAHA XMAX 250 2007 Owners Manual 6. Add the specified amount of the
recommended final transmission
oil, and then install and tighten
the oil filler cap.
EWA11310
s s
WARNING
Make sure that no foreign
material enters the final trans-

Page 53 of 84

YAMAHA XMAX 250 2007 Owners Manual 1. Coolant reservoir cap
ECA10470
CAUTION:
If coolant is not available, use
distilled water or soft tap water
instead. Do not use hard water
or salt water since it is harmful
to the engine.
If water

Page 56 of 84

YAMAHA XMAX 250 2007 Owners Manual EAU21871
Tires
To maximize the performance, durabi-
lity, and safe operation of your
motorcycle, note the following points
regarding the specified tires.
Tire air pressure
The tire air pressure should

Page 57 of 84

YAMAHA XMAX 250 2007 Owners Manual Check the tire condition and air
pressure before each ride.
1. Tire tread depth
Tire inspection
The tires must be checked before
each ride. If the center tread depth
reaches the specified limit, if t

Page 58 of 84

YAMAHA XMAX 250 2007 Owners Manual EAU21960
Cast wheels
To maximize the performance, durabi-
lity, and safe operation of your
motorcycle, note the following points
regarding the specified wheels.
The wheel rims should be chec-
ked for

Page 61 of 84

YAMAHA XMAX 250 2007 Owners Manual EAU23100
Checking and lubricating the
cables
The operation of all control cables
and the condition of the cables
should be checked before each ride,
and the cables and cable ends should
be lubricated

Page 62 of 84

YAMAHA XMAX 250 2007 Owners Manual EAU23211
Checking and lubricating the
centerstand and sidestand
The operation of the centerstand and
sidestand should be checked before
each ride, and the pivots and metal-
to-metal contact surfaces s

Page 63 of 84

YAMAHA XMAX 250 2007 Owners Manual 2. While applying the front brake,
push down hard on the handle-
bars several times to check if the
front fork compresses and
rebounds smoothly.
ECA10590
CAUTION:
If any damage is found or the front
f

Page 64 of 84

YAMAHA XMAX 250 2007 Owners Manual EAU23290
Checking the wheel bearings
The front and rear wheel bearings
must be checked at the intervals spe-
cified in the periodic maintenance and
lubrication chart. If there is play in the
wheel hub
Page:   < prev 1-10 11-20 21-30 31-40 next >