engine oil YAMAHA XVS125 2001 User Guide
[x] Cancel search | Manufacturer: YAMAHA, Model Year: 2001, Model line: XVS125, Model: YAMAHA XVS125 2001Pages: 86, PDF Size: 1.35 MB
Page 73 of 86

7-1
1
2
3
4
5
67
8
9
EAU03430
MOTORCYCLE CARE AND STORAGECareWhile the open design of a motorcy-
cle reveals the attractiveness of the
technology, it also makes it more vul-
nerable. Rust and corrosion can
develop even if high-quality compo-
nents are used. A rusty exhaust pipe
may go unnoticed on a car, however,
it detracts from the overall appear-
ance of a motorcycle. Frequent and
proper care does not only comply
with the terms of the warranty, but it
will also keep your motorcycle looking
good, extend its life and optimize its
performance.Before cleaning
1.Cover the muffler outlets with
plastic bags after the engine has
cooled down.
2.Make sure that all caps and cov-
ers as well as all electrical cou-
plers and connectors, including
the spark plug caps, are tightly
installed.
3.Remove extremely stubborn dirt,
like oil burnt onto the crankcase,
with a degreasing agent and a
brush, but never apply such
products onto seals, gaskets,
sprockets, the drive chain and
wheel axles. Always rinse the dirt
and degreaser off with water.Cleaning
ECA00010
cC8Avoid using strong acidic
wheel cleaners, especially on
spoked wheels. If such prod-
ucts are used on hard-to-
remove dirt, do not leave the
cleaner on the affected area
any longer than instructed.
Also, thoroughly rinse the area
off with water, immediately dry
it, and then apply a corrosion
protection spray.
8Improper cleaning can damage
windshields, cowlings, panels
and other plastic parts. Use
only a soft, clean cloth or
sponge with mild detergent
and water to clean plastic.
5JX-9-E1 9/27/00 10:45 AM Page 72
Page 76 of 86

MOTORCYCLE CARE AND STORAGE
7
7-4
StorageShort-term
Always store your motorcycle in a
cool, dry place and, if necessary, pro-
tect it against dust with a porous
cover.
ECA00014
cC8Storing the motorcycle in a
poorly ventilated room or cov-
ering it with a tarp, while it is
still wet, will allow water and
humidity to seep in and cause
rust.
8To prevent corrosion, avoid
damp cellars, stables (because
of the presence of ammonia)
and areas where strong chemi-
cals are stored.
Long-term
Before storing your motorcycle for
several months:
1.Follow all the instructions in the
ÒCareÓ section of this chapter.
2.Turn the fuel cock lever to ÒONÓ.
3.Drain the carburetor float cham-
bers by loosening the drain bolts;
this will prevent fuel deposits
from building up. Pour the
drained fuel into the fuel tank.
4.Fill up the fuel tank and add fuel
stabilizer (if available) to prevent
the fuel tank from rusting and the
fuel from deteriorating.
5.Perform the following steps to
protect the cylinders, piston
rings, etc. from corrosion.
a.Remove the spark plug caps
and spark plugs.
b.Pour a teaspoonful of engine
oil into each spark plug bore.c.Install the spark plug caps
onto the spark plugs, and then
place the spark plugs on the
cylinder head so that the elec-
trodes are grounded. (This will
limit sparking during the next
step.)
d.Turn the engine over several
times with the starter. (This
will coat the cylinder walls with
oil.)
e.Remove the spark plug caps
from the spark plugs, and then
install the spark plugs and the
spark plug caps.
EWA00003
wTo prevent damage or injury from
sparking, make sure to ground the
spark plug electrodes while turn-
ing the engine over.6.Lubricate all control cables and
the pivoting points of all levers
and pedals as well as of the
sidestand/centerstand.
5JX-9-E1 9/27/00 10:45 AM Page 75
Page 78 of 86

EAU01038
SPECIFICATIONS
8-1
8
Specifications
ModelXVS125
Dimensions
Overall length2,320 mm
Overall width910 mm
Overall height1,075 mm
Seat height670 mm
Wheel base1,530 mm
Ground clearance150 mm
Minimum turning radius2,900 mm
Basic weight (with oil and full
fuel tank)156 kg
Engine
Engine typeAir-cooled 4-stroke, SOHC,
gasoline
Cylinder arrangementV-type 2-cylinder
Displacement124 cm
3
Bore ´Stroke41.0 ´47.0 mm
Compression ratio11:1
Starting systemElectric starter
Lubrication systemWet sumpEngine oil
Type
Recommended engine oil
classificationAPI Service SE, SF, SG type
or higher
cCBe sure to use motor oils that do not contain anti-friction
modifiers. Passenger car motor oils (often labeled ÒEnergy
ConservingÓ) contain anti-friction additives which will cause
clutch and/or starter clutch slippage, resulting in reduced
component life and poor engine performance.
Quantity
Without oil filter element
replacement1.4 L
With oil filter element
replacement1.6 L
Total amount (dry engine)1.75 L
Air filter typeDry element
–10° 0° 10° 20° 30°
40°
SAE 10W/30
SAE 10W/40
SAE 20W/40
SAE 20W/50
–20°
SAE 15W/40 50°C
5JX-9-E1 9/27/00 10:45 AM Page 77