service indicator YAMAHA XVS650A 2001 Owners Manual

3-14
INSTRUMENT AND CONTROL FUNCTIONS
1
23
4
5
6
7
8
9
1. Position indicator
2. Adjusting ring
3. Extension bar
4. Special wrench
EAU00299*
Rear shock absorber adjust-
mentThis shock absorber is equipped with a
spring preload adjuster. Adjust spring
preload as follows:
1. Remove the passenger seat and
rider seat. (See page 3-9 for re-
moval procedures.)2. Use the special wrench and the
extension bar in the owner’s tool
kit to turn the adjusting ring. Turn
the adjusting ring in direction a
to increase spring preload and in
direction b to decrease spring
preload. Make sure that the ap-
propriate notch in the adjusting
ring is aligned with the position in-
dicator on the rear shock absorb-
er.
COPY CI-15ECI-15E3. Install the seats.
SoftStan-
dardHard
Adjusting
position12 3 4567
EAU00315
WARNING
This shock absorber contains high-
ly pressurized nitrogen gas. Read
and understand the following infor-
mation before handling the shock
absorber. The manufacturer cannot
be held responsible for property
damage or personal injury that may
result from improper handling.l
Do not tamper with or attempt
to open the cylinder assembly.
l
Do not subject the shock ab-
sorber to an open flame or oth-
er high heat source. This may
cause the unit to explode due
to excessive gas pressure.
l
Do not deform or damage the
cylinder in any way. Cylinder
damage will result in poor
damping performance.
l
Take your shock absorber to aYamaha dealer for any service.