wheel bolts YAMAHA YBR125 2007 Owners Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
6-4
PREVENTIVE MAINTENANCE SCHEDULE
EVERY 10,000 KM EVERY 10,000 KM
17
Check operation/oil leakage.
REAR SHOCK
ABSORBER
Replace if necessary.
STEERING BEARING
FRONT FORKS 16 15
Check operation/oil leakage. Repair if necessary. Check Bearing assembly for looseness;
Correct if necessary.
Relace oil Repack grease
S.NO ITEMOPERATION
DRIVE CHAIN
NUTS, BOLTS AND
FASTENERS
CENTERSTAND AND
SIDE STAND
Check Chain slack, alignment. Adjust if necessary.
Clean periodically & lubricate.
Check all Chassis fittings and fasteners for looseness.
Tighten as per specification.
Check operation and lubricate if necessary.
Check electrolyte level and top it up if necessary.
Check specific gravity and charge if required.
Check breather pipe for blockage and routing.
CONTROL CABLES
-THROTTLE
-CLUTCH
-FRONT BRAKE 18
19
20
21
BATTERY
22
Readjust or replace as required. Check operation, free play, cable damage
EVERY MONTH
IT IS RECOMMENDED THAT THE ABOVE BE SERVICED BY AUTHORIZED DEALER.
SERVICE MORE FREQUENTLY WHEN THE VEHICLE IS DRIVEN IN DUSTY AREAS.YAMAHA*
EVERY 10,000 KMS
WHEEL BEARING 14
Check Bearing assembly for looseness, damage;
Replace if necessary.
Repack grease
30 Days OR
500-700 KmAFTER EVERY DAYS OR KMS
90 Days OR
2500-2700 Km180 Days OR
4500-5000 KmAFTER
EVERY
2000 KMS

PRE-DELIVERY INSPECTION REPORT
f. Wheels
Tyre :Tyre pressure Solo Double
(PSI)
Front 25 25
Rear 33 36
R i m : Runout - Radial - 1.5 mm (Max)
- Lateral - 1.5 mm (Max)
Spokes : No loosenes
g. Locks Operation : • Ignition
• Steering• Fuel Tank Cap• Side Cover (L.H.)
h. FastenersSpecified Torque
(Ft-Lb)
1. Front Wheel Axle Nuts 25-40
2. Front Fork (Crown Handle & Inner Tube)13-202. Front Fork under Bracket Stem Nut18-223. Handle Bar Mounting Bolts 13-204. Rear Shock Absorber Mounting Bolts22-355. Rear Swing Arm Pivot Shaft Nut32-526. Rear Wheel Axle/Sprocket. Shaft Nuts60-70
B. ENGINE
a. Engine Oil : • Oil Level (For checking - Refer Pg. 6-9)
• Check for any Leakages
10-2
service2.pmd11/3/2006, 8:50 PM 2