relay YAMAHA YBR125 2010 Owners Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
6-28
6
EAU43213
Replacing the fuse The fuse is located behind panel B.
(See page 6-6.)
To access the fuse, disconnect the
starter relay coupler.The spare fuse is located on the rear of
the starter relay holder.
To access the spare fuse, remove the
starter relay (together with its holder) by
pulling it out, then turn the starter relay
over.
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to “OFF” and turn off
all electrical circuits.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage. WARNING! Do not
use a fuse of a higher amperage
rating than recommended toavoid causing extensive dam-
age to the electrical system and
possibly a fire.
[EWA15131]
3. Turn the key to “ON” and turn on
the electrical circuits to check if the
devices operate.
4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
1. Starter relay coupler
1. Fuse
2. Starter relay holder
3. Starter relay
1
23
1. Spare fuse
2. Starter relay holder
3. Starter relay
1
23
Specified fuse:
15.0 A
U51DE0E0.book Page 28 Monday, November 2, 2009 10:34 AM