relay YAMAHA YBR125 2014 Owners Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
6-29
6turne
d to “OFF”, then discon-
nect the neg ative lead b efore
d isconnectin g the positive lea d.
[ECA16303]
2. If the battery will be stored for
more than two months, check it at
least once a month and fully char-
ge it if necessary.
3. Fully charge the battery before installation. NOTICE: When in-
stallin g the battery, be sure the
key is turned to “OFF”, then
connect the positive lea d b efore
connectin g the ne gative lead .
[ECA16841]
4. After installation, make sure that
the battery leads are properly con-
nected to the battery terminals.NOTICE
ECA16531
Always keep the b attery charged .
Storin g a d ischar ged battery can
cause permanent battery dama ge.
EAU43214
Replacin g the fuseThe fuse is located behind panel B.
(See page 6-7.)
To access the fuse, disconnect the
starter relay coupler. The spare fuse is located on the rear of
the starter relay holder.
To access the spare fuse, remove the
starter relay (together with its holder)
by pulling it out, then turn the starter re-
lay over.
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to “OFF” and turn off all electrical circuits.
2. Remove the blown fuse, and then install a new fuse of the specified
amperage. WARNING! Do not
use a fuse of a hi gher ampera ge
ratin g than recommen ded to1. Starter relay coupler
1. Fuse
2. Starter relay holder
3. Starter relay
1
2 3
1. Spare fuse
2. Starter relay holder
3. Starter relay
1
2 3
U51DE1E0.book Page 29 Thursday, August 29, 2013 4:41 PM