engine overheat YAMAHA YFM400F 2001 Owners Manual

4-5
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B061_YFM400FWA-61:YFM600-4.frame
EL
The coolant temperature warning light circuit
can be checked according to the procedure on
page 4-7.
CAUTION:

l
The engine may overheat if the ATV is
overloaded. If this happens, reduce the
load to specification.
l
Restart after making sure that the light is
out. Continuous use while the light is on
may cause damage to the engine.
EBU00605
Four-wheel-drive indicator light “ ”
This indicator light comes on when the
2WD/4WD switch is in the 4WD position.
NOTE:

Due to the synchronizing mechanism in the dif-
ferential gear case, the light may not come on
until the ATV starts moving.

8-75
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B061_YFM400FWA-61:YFM600-8.frame
EL
8. Reinstall the element to the element
guide.
9. Reinstall the element assembly and parts
removed for access.NOTE:The air filter element should be cleaned every
20 ~ 40 hours. It should be cleaned and lubri-
cated more often if the machine is operated in
extremely dusty areas. Each time filter element
maintenance is performed, check the air inlet
to the filter case for obstructions. Check the air
cleaner rubber joint to the carburetor and man-
ifold fittings for an air-tight seal. Tighten all fit-
tings securely to avoid the possibility ofunfiltered air entering the engine.CAUTION:Never operate the engine with the air filter el-
ement removed. This will allow unfiltered air
to enter, causing rapid engine wear and possi-
ble engine damage. Additionally, operation
without the filter element will affect carbure-
tor jetting with subsequent poor performanceand possible engine overheating.
1. Connect the hose.
1. Brancher le flexible.
1. Conecte la manguera.

Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B061_YFM400FWA-61:YFM600-8.frame
ER
8-132
Engine overheatingNOTE:If it is difficult to get the recommended coolant, tap water can be temporarily used, provided that itis changed to the recommended coolant as soon as possible.
WARNING
Wait for the engine and radiator to cool before removing the radiator cap. You could be burned by
hot fluid and steam blown out under pressure. Always put a thick rag over the cap when opening.Allow any remaining pressure to escape before completely removing the cap. Wait until the
engine has cooled.
Check the coolant level in the
reservoir tank and/or radiator.
Level is OK.Level is low, check the
cooling system for leakage.
No
leakage.Leakage.
Ask a Yamaha dealer to inspect
and repair the cooling system.Add coolant. (See NOTE.)
Restart the engine. If the engine overheats again, ask a
Yamaha dealer to inspect and/or repair the cooling system.