heating YAMAHA YFM600FWA 2001 Owners Manual

6-17
EBU00210
Engine break-in
There is never a more important period in the
life of your machine than the period between
zero and 20 hours.
For this reason, we ask that you carefully read
the following material. Because the engine is
brand new, you must not put an excessive load
on it for the first several hours of running. Dur-
ing the first 20 hours, the various parts in the
engine wear and polish themselves to the cor-
rect operating clearances.
During this period, prolonged full throttle oper-
ation or any condition which might result in ex-
cessive engine heating must be avoided.
However, momentary (2 ~ 3 seconds maxi-
mum) full throttle operation under load does
not harm the engine.
Each full throttle acceleration sequence should
be followed with a substantial rest period for
the engine by cruising at lower r/min so the en-
gine can rid itself of the temporary build up of
heat. If any abnormality is noticed during this
period, consult a Yamaha dealer.

8-43
8. Reinstall the element to the element
guide.
9. Reinstall the element assembly and parts
removed for access.
NOTE:
The air filter element should be cleaned every
20 ~ 40 hours. It should be cleaned and lubri-
cated more often if the machine is operated in
extremely dusty areas. Each time filter element
maintenance is performed, check the air inlet
to the filter case for obstructions. Check the air
cleaner rubber joint to the carburetor and man-
ifold fittings for an air-tight seal. Tighten all fit-
tings securely to avoid the possibility of
unfiltered air entering the engine.
CAUTION:
Never operate the engine with the air filter el-
ement removed. This will allow unfiltered air
to enter, causing rapid engine wear and possi-
ble engine damage. Additionally, operation
without the filter element will affect carbure-
tor jetting with subsequent poor performance
and possible engine overheating.