8-17
Yuki_DATA2:HM00G210_YFM660R-60:YFM350-8.frameEL
1. Engine oil tank
2. Engine oil filler cap
3. Maximum level mark
4. Minimum level mark
1. Réservoir d’huile de moteur
2. Bouchon de remplissage de l’huile de moteur
3. Repère de niveau maximum
4. Repère de niveau minimum
1. Depósito de aceite de motor
2. Tapa de relleno de aceite de motor
3. Marca de nivel máximo
4. Marca de nivel mínimo
EBU00812
Engine oil and oil filter cartridge
The engine oil level should be checked before
each ride. In addition, the oil must be changed
and the oil filter cartridge replaced at the inter-
vals specified in the periodic maintenance and
lubrication chart.
To check the engine oil level
1. Place the ATV on a level surface.
2. Start the engine, warm it up until the en-
gine oil has reached a normal tempera-
ture of 60˚C, let it continue to idle for ten
seconds, and then turn the engine off.
NOTE:
To achieve the proper engine oil temperature
for an accurate oil level reading, the engine
must have first completely cooled down, and
then warmed up again for several minutes to
normal operating temperature.
3. Wait a few minutes until the oil settles, re-
move the engine oil tank filler cap, wipe
the dipstick clean, insert it back into the
filler hole (without screwing it in), and
then remove it again to check the oil level.
8-19
Yuki_DATA2:HM00G210_YFM660R-60:YFM350-8.frameEL
NOTE:
The engine oil should be between the mini-
mum and maximum level marks.
4. If the engine oil is below the minimum
level mark, add sufficient oil of the recom-
mended type to raise it to the correct lev-
el.
NOTE:
When adding oil, be careful not to overfill the
engine; the oil level rises faster starting from
the half-level-portion on the dipstick.
5. Insert the dipstick into the oil filler hole,
and then tighten the oil filler cap.
CAUTION:
Make sure that the oil filler cap is securely
tightened, otherwise oil may seep out when
the engine is running.
