oil type YAMAHA YFM660R 2001 Notices Demploi (in French)

5-13
Yuki_DATA2:HM00G210_YFM660R-60:YFM350-5.frameEL
EBU00485
Engine oil
Make sure the engine oil is at the specified lev-
el. Fill with oil as necessary. (See pages 8-17 ~
8-29 for details.)
Te m p .
-20°-10°0°10°20°30°40°50°C
5W/30
10W/30
10W/40
20W/50
15W/40
20W/40
Recommended oil:
Recommended engine oil classification:
API Service SE, SF, SG type or higher

8-19
Yuki_DATA2:HM00G210_YFM660R-60:YFM350-8.frameEL
NOTE:
The engine oil should be between the mini-
mum and maximum level marks.
4. If the engine oil is below the minimum
level mark, add sufficient oil of the recom-
mended type to raise it to the correct lev-
el.
NOTE:
When adding oil, be careful not to overfill the
engine; the oil level rises faster starting from
the half-level-portion on the dipstick.
5. Insert the dipstick into the oil filler hole,
and then tighten the oil filler cap.
CAUTION:
Make sure that the oil filler cap is securely
tightened, otherwise oil may seep out when
the engine is running.

8-27
Yuki_DATA2:HM00G210_YFM660R-60:YFM350-8.frameEL
10. Add sufficient oil of the recommended
type to raise it to the correct level, and
then install and tighten the oil tank filler
cap.
CAUTION:
In order to prevent clutch slippage (since
the engine oil also lubricates the clutch),
do not mix any chemical additives with
the oil or use oils of a higher grade than
“CD”. In addition, do not use oils labeled
“ENERGY CONSERVING II” or higher.
Make sure that no foreign material enters
the crankcase. Recommended engine oil:
See page 10-2.

8-63
Yuki_DATA2:HM00G210_YFM660R-60:YFM350-8.frameEL
3. Refill with the same type of brake fluid.
Mixing fluids may result in a harmful
chemical reaction and lead to poor brake
performance.
4. Be careful that water does not enter the
master cylinder when refilling. Water will
significantly lower the boiling point of the
fluid and may result in vapor lock.
5. Brake fluid may deteriorate painted sur-
faces or plastic parts. Always clean up
spilled fluid immediately.
6. Have a Yamaha dealer check the cause if
the brake fluid level goes down.

Yuki_DATA2:HM00G210_YFM660R-60:YFM350-SPEC-E.frameEL
10-1
EBU00428
SPECIFICATIONS
MODEL YFM660R
Dimension:
Overall length
Overall width
Overall height
Seat height
Wheel base
Ground clearance
Minimum turning radius1,830 mm
1,100 mm
1,150 mm
860 mm
1,245 mm
265 mm
3,300 mm
Basic weight:
With oil and full fuel tank 193 kg
Engine:
Type
Cylinder arrangement
Displacement
Bore× Stroke
Compression ratio
Starting system
Lubrication systemLiquid-cooled, 4-stroke, SOHC
Single cylinder, forward inclined
660 cm
3
100
× 84 mm
9.2 : 1
Electric starter
Dry sump

Yuki_DATA2:HM00G210_YFM660R-60:YFM350-SPEC-E.frame
10-2
ER
10
10
10
10
10
10
10
10
10
10
101
Engine oil:
Type-20°-10°0°10°20°30°40°50°C
5W/30
10W/30
10W/40
20W/50
20W/40
15W/40
Recommended engine oil classification API Service SE, SF, SG type or higher
Quantity:
Periodic oil change
With oil filter cartridge replacement
Total amount1.9 L
1.95 L
2.3 L MODEL YFM660R
CAUTION:
Be sure to use motor oils that do not contain anti-
friction modifiers. Passenger car motor oils (often
labeled “Energy Conserving”) contain anti-friction
additives which will cause clutch and/or starter
clutch slippage, resulting in reduced component
life and poor engine performance.

Yuki_DATA2:HM00G210_YFM660R-60:YFM350-SPEC-E.frameER
10-4
Gear ratio:
1st
2nd
3rd
4th
5th
Reverse34/14 (2.428)
29/19 (1.526)
26/21 (1.238)
22/21 (1.047)
19/21 (0.904)
28/23× 23/16 (1.750)
Chassis:
Frame type
Caster angle
TrailSteel tube
8

°
47 mm
Tire:
Type
Size: Front
Size: RearTubeless
AT21
× 7 - 10
AT20
× 10 - 9
Brake:
Front brake type
Operation
Rear brake type
OperationDual disc brake
Right hand operation
Single disc brake
Right foot operation
Suspension:
Front
RearDouble wishbone
Swingarm (link suspension)
Shock absorber:
Front
RearCoil spring/oil damper
Coil spring/gas-oil damper MODEL YFM660R