steering wheel YAMAHA YFM700R 2006 Manuale de Empleo (in Spanish)

7-61
CROSSING A SLOPE
Traversing a sloping surface on your ATV
requires you to properly position your weight to
maintain proper balance. Be sure that you have
learned the basic riding skills on flat ground
before attempting to cross a sloping surface.
Avoid slopes with slippery surfaces or rough ter-
rain that may upset your balance.
As you travel across a slope, lean your body in
the uphill direction. It may be necessary to cor-
rect the steering when riding on loose surfaces
by pointing the front wheels slightly uphill. When
riding on slopes be sure not to make sharp turns
either up or down hill.
1S3-9-60 7 4/26/05 6:27 PM Page 204

7-71
SLIDING AND SKIDDING
Care should be used when riding on loose or
slippery surfaces since the ATV may slide. If
unexpected and uncorrected, sliding could lead
to an accident.
To reduce the tendency for the front wheels to
slide in loose or slippery conditions, positioning
your weight over the front wheels will sometimes
help.
If the rear wheels of your ATV start to slide side-
ways, control can usually be regained (if there is
room to do so) by steering in the direction of the
slide. Applying the brakes or accelerating is not
recommended until you have corrected the
slide.
1S3-9-60 7 4/26/05 6:27 PM Page 214

8-8
INITIAL EVERY
month 1 3 6 6 12
ITEM ROUTINEWhichever
km 320 1200 2400 2400 4800 comes first
(mi) (200) (750) (1500) (1500) (3000)
hours 20 75 150 150 300
Air filter element9Clean. Every 20–40 hours
9Replace if necessary. (more often in wet or dusty areas)
Clutch*9Check operation.
2222
9Adjust if necessary.
9Check free play/operation/fluid leakage/
Front brake*See NOTE Page 8-10.22222
9Correct if necessary.
9Check operation/fluid leakage/
Rear brake*See NOTE Page 8-10.22222
9Correct if necessary.
Wheels*9Check balance/damage/runout.
2222
9Replace if necessary.
Wheel bearings*9Check bearing assemblies for looseness/damage.
2222
9Replace if damaged.
Rear arm pivot*9Lubricate with lithium-soap-based grease.222
Upper and lower arm
pivot and steering 9Lubricate with lithium-soap-based grease.222
shaft*
Drive chain9Check and adjust slack/alignment/clean/lube.22222
Fittings and fasteners*9Check all chassis fittings and fasteners.
22222
9Correct if necessary.
Front and rear9Check operation.
22
suspension*9Correct if necessary.
1S3-9-60 8 6/7/05 10:25 AM Page 8-8