suspension YAMAHA YFM700R 2019 Owners Manual

2-5
2
ungrounded or broken wiring. Visually check
for broken wiring and leaking fuel. Leaking
fuel can be confirmed by the odor of gasoline.
4. Once immediate safety hazards are con- firmed not to exist, you may remove your hel-
met to more closely inspect your vehicle.
Check for external signs of wear, broken
parts, fluid leaks, cracks in the frame, sus-
pension damage, wheel damage, and so on.
Fuel, oil, and coolant usually give off a notice-
able odor.
5. If your vehicle will not restart or if it is unsafe to ride, then turn off all vehicle systems (en-
gine stop switch, main switch, and fuel cock),
and then signal or go for help.
Aftermarket Parts, Accessories, and Modifica-
tions
While you may find aftermarket products similar in
design and quality to genuine Yamaha accesso-
ries, recognize that some aftermarket accessories
or modifications are not suitable because of po-
tential safety hazards to you or others. Installing
aftermarket products or having other modifica-
tions performed to your vehicle that change any of
the vehicle’s design or operation characteristics
can put you and others at greater risk of serious injury or death. You are responsible for injuries re-
lated to changes in the vehicle. Keep the following
guidelines in mind, as well as those found in the
Loading section (page 6-6) when mounting acces-
sories.

Never install accessories that would impair the
performance of your ATV. Carefully inspect the
accessory before using it to make sure that it
does not in any way reduce ground clearance,
limit suspension travel, steering travel or control
operation.
 Accessories fitted to the ATV can create insta-
bility due to improper weight distribution.
 Bulky or large accessories may seriously affect
the stability of the ATV.
 Certain accessories can displace the operator
from his or her normal riding position. This im-
proper position limits the freedom of movement
of the operator and may limit control ability,
therefore, such accessories are not recom-
mended.
 Use caution when adding electrical accesso-
ries. If electrical accessories exceed the capac-
ity of the ATV’s electrical system, an electric
failure could result, which could cause a dan-
UBB561E0.book Page 5 Monday, March 26, 2018 11:15 AM

4-15
4
 Do not exceed the load limit of 2.0 kg (4 lb) for
the storage compartment.
 Do not exceed the maximum load of 240.0 kg
(530 lb) for the ATV.
EBU18964Front carrierDo not exceed the load limit of 40.0 kg (88 lb) for
the front carrier.
 Do not exceed the maximum load of 240.0 kg
(530 lb) for the ATV.
EBU18974Rear carrierDo not exceed the load limit of 80.0 kg (176 lb)
for the rear carrier.
 Do not exceed the maximum load of 240.0 kg
(530 lb) for the ATV.EBU1914AFront and rear shock absorbers The spring preload can be adjusted to suit the rid-
er’s weight and the riding conditions.
WARNING
EWB00401Always adjust the shock absorber assemblies
on the left and right side to the same setting.
Uneven adjustment can cause poor handling
and loss of stability, which could lead to an ac-
cident. Adjust the spring preload as follows.
Turn the spring preload adjusting ring in direction
(a) to increase the spring preload and thereby
harden the suspension, and in direction (b) to de-
crease the spring preload and thereby soften the
suspension.
Align the appropriate notch in the adjusting ring
with the position indicator on the shock absorber.
1. Storage compartment
1
UBB561E0.book Page 15 Monday, March 26, 2018 11:15 AM

10-4
10
Rear:30.0 kPa (0.300 kgf/cm², 4.4 psi)
(YFM45KDXK_AUS/NZL, YFM45KPXK_AUS/NZL)
Minimum (For Oceania): Front:
32.0 kPa (0.320 kgf/cm², 4.6 psi)
(YFM45KDXK_AUS/NZL, YFM45KPXK_AUS/NZL)
Rear:
27.0 kPa (0.270 kgf/cm², 3.9 psi)
(YFM45KDXK_AUS/NZL, YFM45KPXK_AUS/NZL)
No cargo or trailer (For Europe):
Front:35.0 kPa (0.350 kgf/cm², 5.0 psi) (YFM45KDHK,
YFM45KDXK_EUR/FRA/GBR, YFM45KPHK,
YFM45KPLK, YFM45KPXK_EUR/FRA/GBR)
Rear: 30.0 kPa (0.300 kgf/cm², 4.4 psi) (YFM45KDHK,
YFM45KDXK_EUR/FRA/GBR, YFM45KPHK,
YFM45KPLK, YFM45KPXK_EUR/FRA/GBR)
With cargo or trailer (For Europe):
Front:50.0 kPa (0.500 kgf/cm², 7.3 psi) (YFM45KDHK,
YFM45KDXK_EUR/FRA/GBR, YFM45KPHK,
YFM45KPLK, YFM45KPXK_EUR/FRA/GBR)
Rear: 50.0 kPa (0.500 kgf/cm², 7.3 psi) (YFM45KDHK,
YFM45KDXK_EUR/FRA/GBR, YFM45KPHK,
YFM45KPLK, YFM45KPXK_EUR/FRA/GBR)
Front wheel:Rim size:12 x 6.0AT
Rear wheel:Rim size:12 x 7.5ATFront brake:Type:Hydraulic disc brakeRear brake:Type:
Mechanical wet multiple disc brakeBrake fluid:Specified brake fluid:DOT 4Front suspension:Type:Double wishbone
Spring: Coil spring
Shock absorber:
Gas-hydraulic damper
Wheel travel: 171 mm (6.8 in)Rear suspension:Type:
Double wishbone
Spring: Coil spring
Shock absorber: Gas-hydraulic damper
Wheel travel:
189 mm (7.4 in)
UBB561E0.book Page 4 Monday, March 26, 2018 11:15 AM