engine overheat YAMAHA YFZ450 2006 Manuale de Empleo (in Spanish)

4-5
3. Push the start switch. If the warning light
does not come on while the start switch is
pushed, have a Yamaha dealer check the
electrical circuit.
cC
8The engine may overheat if the ATV is
overloaded. If this happens, reduce the
load to specification.
8Restart after making sure that the light is
off. Continuous use while the light is on
may cause damage to the engine.
5TG-9-63 4 9/16/05 4:29 PM Page 4-5

4-19
1. Parking brake lever (Locked position)1.Levier de frein de stationnement (frein serré)1. Palanca del freno de estacionamiento (posición de bloqueo)
1. Parking brake lever (Unlocked position)
1.Levier de frein de stationnement (frein relâché)1. Palanca del freno de estacionamiento
(posición de desbloqueo)
EBU14072
Parking brake lever
Use the parking brake when you have to start
the engine or park the machine, especially on a
slope. To apply the parking brake, move the
parking brake lever in direction
a. To release
the parking brake, move the parking brake lever
in direction b.
w
8Always set the parking brake before start-
ing the engine. The ATV could start mov-
ing unexpectedly if the parking brake is
not applied. This could cause loss of con-
trol or a collision.
8Always be sure you have released the
parking brake before you begin to ride.
The brake could overheat if you ride the
ATV without releasing the parking brake.
You could lose braking performance
which could cause an accident. You could
also wear out the brakes prematurely.
5TG-9-63 4 9/16/05 4:29 PM Page 4-19

8-73
NOTE:
The air filter element should be cleaned every
20-40 hours. It should be cleaned and lubricated
more often if the machine is operated in
extremely dusty areas. Each time air filter ele-
ment maintenance is performed, check the air
inlet to the air filter case for obstructions. Check
the air intake duct between the air filter case and
the carburetor and the manifold fittings for an
airtight seal. Tighten all fittings securely to avoid
the possibility of unfiltered air entering the
engine.
cC
Never operate the engine with the air filter
element removed. This will allow unfiltered
air to enter the engine, causing rapid engine
wear and possible engine damage.
Additionally, operation without the air filter
element will affect carburetor jetting with
subsequent poor performance and possible
engine overheating.
5TG-9-63 8 10/26/05 4:54 PM Page 8-73

8-150
Engine overheating
NOTE:
If it is difficult to get the recommended coolant, tap water can be temporarily used, provided that it is
changed to the recommended coolant as soon as possible.
w
Wait for the engine and radiator to cool before removing the radiator cap. You could be burned
by hot fluid and steam blown out under pressure. Always put a thick rag over the cap when
opening. Allow any remaining pressure to escape before completely removing the cap.
Wait until the
engine has cooled.Check the coolant level in the
reservoir tank and/or radiator.
Level is OK.
Level is low, check the
cooling system for leakage.
No
leakage.
Leakage.Ask a Yamaha dealer
to inspect and repair
the cooling system.
Add coolant.
(See NOTE.)
Restart the engine. If the engine overheats
again, ask a Yamaha dealer to inspect and/or
repair the cooling system.
5TG-9-63 9-11 10/27/05 9:32 AM Page 8-150