oil dipstick YAMAHA YFZ450 2006 Manuale de Empleo (in Spanish)
[x] Cancel search | Manufacturer: YAMAHA, Model Year: 2006, Model line: YFZ450, Model: YAMAHA YFZ450 2006Pages: 444, tamaño PDF: 5.75 MB
Page 284 of 444
8-27
3. Remove the engine oil tank filler cap, wipe
the dipstick clean with a clean rag, insert it
back into the filler hole (without screwing it
in), and then remove it again to check the
oil level.
NOTE:
The engine oil should be between the minimum
and maximum level marks.
4. If the engine oil is below the minimum level
mark, add sufficient oil of the recommend-
ed type through the engine oil tank filler
hole to raise it to the correct level.
NOTE:
When adding oil, be careful not to overfill the
engine oil tank; the oil level rises faster starting
from the half-level-portion on the dipstick.
5. Insert the dipstick into the engine oil tank
filler hole, and then tighten the engine oil
tank filler cap.
1. Engine oil tank 2. Engine oil tank filler cap
3. Dipstick 4. Maximum level mark
5. Minimum level mark 6. Engine oil filler cap
1. Réservoir d’huile de moteur
2. Bouchon de remplissage de l’huile de moteur
3. Jauge
4. Repère de niveau maximum
5. Repère de niveau minimum
6. Bouchon de remplissage d’huile de moteur
1. Depósito de aceite de motor
2. Tapa de relleno del depósito de aceite de motor
3. Varilla de medición
4. Marca de nivel máximo
5. Marca de nivel mínimo
6. Tapa del filtro de aceite de motor
5TG-9-63 8 10/26/05 4:54 PM Page 8-27
Page 292 of 444
8-35
11. Install the crankcase engine oil drain bolt
and the engine oil tank drain bolt, and then
tighten them to the specified torques.
12. Pour the specified amount of recommend-
ed engine oil through the engine oil tank
filler hole, insert the dipstick, and then
tighten the engine oil tank filler cap.
13. Pour the specified amount of recommend-
ed engine oil through the engine oil filler
hole, and then install and tighten the
engine oil filler cap.
Tightening torque:
Oil filter element cover bolt:
10 Nm (1.0 m0kgf)
Tightening torques:
Crankcase engine oil drain bolt:
20 Nm (2.0 m0kgf)
Engine oil tank drain bolt:
19 Nm (1.9 m0kgf)
5TG-9-63 8 10/26/05 4:54 PM Page 8-35